Second Edition • Fourth Printing | Operator’s Manual |
|
|
|
|
Operating Instructions
Do Not Operate Unless:
You learn and practice the principles of safe machine operation contained in this operator's manual.
1Avoid hazardous situations.
2Always perform a
3Always perform function tests prior to use.
4Inspect the work place.
5Only use the machine as it was intended.
Fundamentals
Using the machine for anything other than lifting personnel and tools to an aerial work site is unsafe.
If more than one operator is expected to use a machine at different times in the same work shift, each operator is expected to follow all safety rules and instructions in the operator's manual. That means every new operator should perform a pre- operation inspection, function tests and a work place inspection before using the machine.
Setup
1Pump the foot pedal to raise the base until the wheels contact the ground.
2Use the steering handle to push the machine.
3Position the machine on a firm, level surface directly below the work area.
4Pull the base lowering handle to lower the base until all four foot pads are in firm contact with the ground.
5Connect to an appropriate power source: DC models: Connect battery pack.
AC models: Connect to a grounded
15A AC power supply. Use a 12 gauge / 3.3mm2
6Insert the key and turn to the ON position OR to platform control.
7Pull out the red Emergency Stop button at the ground controls and be sure the power light is on.
8Check the interlock display. Be sure that all four display lights are on.
Part No.48643 | Genie IWP Super Series | 17 |