Genie 48643 manual Transport Instructions, Winching the Machine onto a FlatbedTruck

Page 23

Second Edition • Fourth Printing

Operator’s Manual

 

 

 

 

Transport Instructions

Observe and Obey:

Common sense and planning must be applied to control the movement of the machine when lifting it with a crane or forklift.

The transport vehicle must be parked on a level surface.

The transport vehicle must be secured to prevent rolling while the machine is being loaded.

Vehicle capacity, loading equipment and surfaces must be capable of supporting the machine weight. See Specifications section.

The base of the machine must remain lowered during all loading and transport procedures.

The machine must be secured to the transport vehicle with chains or straps of ample load capacity.

Winching the Machine onto a FlatbedTruck

1Lower the platform.

2Push in the red Emergency Stop buttons, turn the key switch to the OFF position and remove the key.

3Inspect the entire machine for loose or unsecured items.

4Connect the cable to the winching point located on the front of the base.

5Carefully winch the machine onto the truck.

6Secure the machine base and mast to the transport vehicle. Use chains or straps of ample load capacity.

Loading the Machine With a Forklift

Use the forklift pockets located on the sides of the machine or the forklift rings located behind the counterweight under the platform.

Be sure to inspect the machine and remove any loose or unsecured items.

To use the forklift rings:

1Raise the platform 3 inches / 7.5 cm.

2 Position the forklift rings in the up position.

Loading the Machine With a Crane

Use the lifting eye mounted on the rear mast column.

The battery pack must be removed before lifting the machine with a crane.

Be sure to inspect the machine and remove any loose or unsecured items.

Always place the lifting hook through the lifting eye so that it points away from the machine.

Part No.48643

Genie IWP Super Series

21

Image 23
Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesCSA Tip-over HazardsElectrocution Hazards Fall HazardsBodily Injury Hazard Collision HazardsDamaged Machine Hazards Improper Use HazardDecal Legend Outreach Option Safety Bodily Injury HazardPower Wheel Assist Option Safety Collision Hazards Lifting Hazard Battery and Charger Safety DC Models Burn HazardsExplosion Hazards Ground Controls Platform Controls ControlsPage Fundamentals Pre-operation InspectionPre-operation Inspection Check the Battery DC Models Observe and Obey MaintenanceCheck the Hydraulic Oil Level Scheduled MaintenanceFunction Tests Test Interlock System Function TestsTest Auxiliary Platform Lowering Workplace Inspection Operating Instructions SetupAuxiliary Platform Lowering Emergency StopPlatform Raise & Lower Manual LoweringOutreach Option Operating Instructions Power Wheel Assist Option Operating InstructionsDry Battery Filling Charging Instructions Battery and Charger Instructions Observe and ObeyTo Charge Battery Loading the Machine With a Crane Transport InstructionsWinching the Machine onto a FlatbedTruck Loading the Machine With a ForkliftDecal Inspection DecalsOutreach Option IWP-20S IWP-25S SpecificationsSpecifications Distributed By