AC applications
1.Start the engine and make sure the pilot lamp comes on. If not, check the filament.
2.Switch on the AC Circuit Breaker.
NOTE: Although voltage adjustment is usually not required, fine adjust- ments may be made by turning the voltage adjustment knob. Use the generator at the specified voltage (12OV).
3.Plug in the appliance; always
CAUTION: Be sure that appliances do not exceed the generator’s rated load capacity for more than 30 minutes and that they never exceed the maximum load capacity. Substantial overloading will switch off the circuit breaker. Marginal overloading may not switch off the circuit breaker, but it will shorten the service life of the generator.
Be sure that all appliances are in good working order before connecting them to the generator. If an appliance begins to operate abnormally, becomes sluggish, or stops suddenly, turn off the circuit breaker and the generator engine switch immediately. Then disconnect the appliance and examine it for signs of malfunction.
NOTE: If an overloaded circuit causes the AC circuit breaker to switch off, reduce the electrical load on the circuit and wait a few minutes before resetting the circuit breaker.
VOLT | METER | AC CIRCUIT |
|
! | BREAKER | , PILOT LAMP | |
I | I |
|
’~V~L~GE
ADJUSTMENT | KNOB\ | ) |
12