Honda Power Equipment EM1800X, EM2200X, EM1600X owner manual Plug Wrench Spark Plug CAP

Page 22

Spark plug service

Recommended spark plug: BPGES, BPRGES (NGK)

W20EP-U, W20EPR-U (ND)

To ensure proper engine operation, the spark plug must be properly gapped and free of deposits.

1.Remove the spark plug cap.

2.Clean any dirt from around the spark plug base.

3.Use the wrench supplied in the tool kit to remove the spark plug.

PLUG

WRENCH

SPARK

PLUG CAP

4.Visually inspect the spark plug. Discard it if the insulator is cracked or chipped. Clean the spark plug with a wire brush if it is to be reused.

5.Measure the plug gap with a feeler gauge.

The gap should be 0.7-0.8 mm (0.028~0.031 in). Correct as necessary by carefully bending the side electrode.

0.7-m mm

(0.028~0.031 in)

20

Image 22
Contents Generator Page Page Contents Generator Safety Component Identification Fuel PRE-OPERATION Check Fuel Gauge Starting the Engine Page Engine Switch OIL Alert Lampe Generator USE Volt Meter AC Circuit Breaker Pilot Lamp DC Circuit Breaker Stopping the Engine Maintenance Maintenance Schedule OIL Filler OIL Drain Plug Reinstall the air cleaner element and the cover Rubber Gasket Filter CUP Plug Wrench Spark Plug CAP Page Protector Page TRANSPORTING/STORAGE Troubleshooting Defects WIR Light Blue Page Specifications Honda GX140Warranty Service Memo Page Page 31ZB1010