Generac 4451, 4582 owner manual Battery Connection, Handle Assembly

Page 7

Section 1 - General Information

Commercial-Industrial-Residential Portable Generator System

Figure 2 - Handle Assembly

1.2.3 BATTERY CONNECTION

•The battery shipped with the generator has been provided fully charged. Caution must be taken when connecting the battery.

•Cut the tie wrap cable holding the RED and BLACK battery cables to the stator.

•Connect the RED battery cable to the battery Positive terminal

(+). After making sure that the connection is tight, slip the rubber boot over the terminal connection.

•Connect the BLACK battery cable to the battery Negative terminal (–). Make sure the connection is tight.

•Double check all connections to ensure they are in the correct location and secure. See Figure 3 at right.

Figure 3 - Battery Connections

Negative	Positive
Cable	Cable

5

Image 7

Contents Owner’s Manual Safety Rules General Information Introduction General Hazards Important Safety InstructionsExplosion Hazards Electrical HazardsFire Hazards Assembling the Wheel KIT AssemblyAccessory BOX UnpackingHandle Assembly Battery ConnectionKnow the Generator Operation1 AC, 20 AMP, Duplex Receptacle Cord Sets and Connection Plugs2 120V AC, 20 AMP, Gfci Receptacle Provided. This receptacle can not recharge 6 Volt batteries 5 12 Volt DC, 10 AMP ReceptacleGrounding the Generator HOW to USE the GeneratorConnecting Electrical Loads DON’T Overload the GeneratorBefore Starting the Generator Wattage Reference GuideAdding Engine OIL Adding Gasoline To Start the EngineStopping the Engine Automatic Idle ControlCold Weather OPERATION/ DE-ICER LOW OIL Pressure Shutdown SystemTo recharge 12 Volt batteries, proceed as follows Charging a BatteryEngine Specifications Maintenance ScheduleProduct Specifications Generator SpecificationsGeneral Recommendations Clean Spark Arrestor Screen Service AIR CleanerReplacing the Spark Plug To adjust valve clearance Adjusting Valve ClearanceLong Term Storage Storage GeneralOther Storage Tips Troubleshooting Commercial-Industrial-Residential Portable Generator System Commercial-Industrial-Residential Portable Generator System Wiring Diagram Drawing No E0228 Schematic Drawing No E0229-A GT-990 & GT-760 Engine Page 1 Drawing No E8589E Item Part NO. QTY. Description GT-990 & GT-760 Engine Page 2 Drawing No E8589E QTY Description Generator Drawing No D4488-D QTY. Description Control Panel Drawing No E0227B Part NO. QTY. Description Frame, Handle & Wheel Kit Drawing No E0695-A QTY Description California Emission Control Warranty Statement Emission Control System Warranty Warranty Schedule Generac Power SYSTEMS, INC. P.O. Box 297 Whitewater, WI