Carrier ASPASICCA015 Checking the Engine OIL Level, Changing the Engine OIL, OIL Change Procedure

Section 3 -- Maintenance

Carrier Air-cooled 7 kW, 12 kW and 15 kW Generators

POS__

iNSTALLATiON

STAR.UP

ADJUSTMENTS

	Figure	3.1	-	Generator Control Panel		Figure 3.3 --Oil Dipstick and Fill,
						12 kW and 15 kW
'					EX EEHNAL	0H Dipstick
I 0UTLET FUSE	z			_	GFCI
						\
						\
75A	......			_ C_RGU_T
	AUTO	OFF	MAN		BREAKER

12 VDC

SYST

O	ii •	ii
	SET
	EXERCISE	ACCESSORY
	TIME	OUTLET 75A MAX

3.2CHECKING THE ENGINE OIL LEVEL

For oil capacities, see "Specifications," Section 1.5. For engine oil recommendations, see Section 3.3.1. To check the engine oil level, proceed as follows (Figures

3.2 and 3.3):

1.Start the generator by moving the AUTO/OFF/ MANUAL switch to the MANUAL position. Allow it to run for a short while and then shut it down by moving the switch to the OFF position.

2.Remove the dipstick and wipe it dry with a clean cloth.

3.Install the dipstick; then, remove it again. The oil level should be at the dipstick "Full" mark. If necessary, add oil to the "Full" mark only. DO NOT FILL ABOVE THE "FULL" MARK.

"_ CAUTBON

_l Never operate the engine with the oil level below the "Add" mark on the dipstick. Doing

this could damage the engine.

4.Install the dipstick.

5.Reset the AUTO/OFF/MANUAL switch to its original position.

NOTE:

If the generator is to operate continuously for several days the oil level should be monitored frequently. A low oil shutdown can occur (Section 2.7.1) causing loss of generator power to emergency circuits.

Figure 3.2 --Oil Dipstick and Fill, 7 kW

Dipstick and Fill

3.3CHANGING THE ENGINE OIL

3.3.1ENGINE OIL RECOMMENDATIONS

Use oil of American Petroleum institute (API) Service Class SG, SH or SJ. Use all season SAE 5W-30Synthetic oil. Organic break-in oil is required before using synthetic oil.

NOTE:

The unit is supplied with organic "break-in" oil. See the "Break-in Procedure," Section 2.1, for the first required oil change.

CAUTION

_Any attempt to crank or start the engine before it has been properly serviced with the

recommended oil may result in an engine failure.

3.3.2OIL CHANGE PROCEDURE

To change the oil, proceed as follows:

1.Run the engine until it is thoroughly warmed up then shut OFF the engine.

2.Immediately after the engine shuts OFF, pull the oil drain hose (Figure 3.4) free of its retaining clip. Remove the cap from the hose and drain the oil into a suitable container.

3.After the oil has drained, replace the cap onto the end of the oil drain hose. Retain the hose in the clip.

4.Refill with the proper recommended oil (see Section 3.3.1 ). See Section 1.5.2 for oil capacities.

Carrier 1 3