Carrier ASPASICCA012, ASPASICCA015, ASPASICCA007 owner manual Emission Control System Warranty

Page 23

Section 6 - Warranty

CarrierAir-cooled 7 EW, 12 EW and 15 EW Generators

EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (ECS Warranty) for 1995 and later model year engines:

(a)Applicability: This warranty shall apply to 1995 and later model year engines. The ECS Warranty Period shall begin on the date the new engine or equipment is purchased by/delivered to its original, end-use purchaser/owner and shall continue for 24 consecutive months thereafter.

(b)General Emissions Warranty Coverage: Generac warrants to the original, end-use purchaser/owner of the new engine or equipment and to each subsequent purchaser/owner that each of its engines is ...

(1)Designed, built and equipped so as to conform with all applicable regulations adopted by the CARB pursuant to its authority, and

(2)Free from defects in materials and workmanship which, at any time during the ECS Warranty Period, may cause a warranted emissions-related part to fail to be identical in all material respects to the part as described in the engine manufacturer's application for certification.

(c)The ECS Warranty only pertains to emissions-related parts on your engine, as follows:

(1)Any warranted, emissions-related parts that are not scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Generac according to Subsection (4) below. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(2)Any warranted, emissions-related part that is scheduled only for regular inspection as specified in the Owner's Manual shall be warranted for the ECS Warranty Period. A statement in such written instructions to the effect of "repair or replace as necessary" shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(3)Any warranted, emissions-related part that is scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by Generac according to Subsection (4) below. Any such emissions-related part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period prior to the first scheduled replacement point for such emissions-related part.

(4)Repair or replacement of any warranted, emissions-related part under this ECS Warranty shall be performed at no charge to the owner at a Generac Authorized Warranty Service Facility.

(5)When the engine is inspected by a Generac Authorized Warranty Service Facility, the owner shall not be held responsible for diagnostic costs if the repair is deemed warrantable.

(6)Generac shall be liable for damages to other original engine components or approved modifications proximately caused by a failure under warranty of any emission-related part covered by the ECS Warranty.

(7)Throughout the ECS Warranty Period, Generac shall maintain a supply of warranted emission-related parts sufficient to meet the expected demand for such emission-related parts.

(8)Any Generac authorized and approved emission-related replacement part may be used in the performance of any ECS Warranty maintenance or repairs and wil! be provided without charge to the owner. Such use shall not reduce Generac ECS Warranty obligations.

(9)Unapproved, add-on, modified, counterfeit and/or "grey market" parts may not be used to modify or repair a Generac engine. Such use voids this ECS Warranty and shall be sufficient grounds for disallowing an ECS Warranty claim. Generac shall not be held liable hereunder for failures of any warranted parts of a Carrier engine caused by the use of such an unapproved, add-on, modified, counterfeit and/or "grey market" part.

EMISSION RELATED PARTS INCLUDE THE FOLLOWING:

1) Fuel Metering

System:

 

3)

Ignition

System including:

1.2)

LPG/Natural

Gas carburetion

assembly and its internal

 

a) Spark

plug

components.

 

 

 

 

b) Ignition

module

a) Fuel controller (if so equipped)

 

4)

Catalytic

Muffler Assembly (if so equipped) including:

 

 

 

 

 

b)

Mixer and

its

gaskets (if so equipped)

 

a) Muffler

gasket

c) Carburetor and its gaskets (if so equipped)

 

b) Exhaust

manifold

 

 

 

 

 

 

d) Primary gas regulator (if so equipped)

5)

Crankcase

Breather Assembly including:

e) LP liquid vaporizer (if so equipped)

 

a) Breather

connection tube

 

 

 

 

 

 

2)Air Induction System including:

a)Intake pipe/manifold

b)Air cleaner

*Generac engine types covered by this warranty statement include the following:

1)Prepackaged Standby Generator

2)Auxiliary Power Unit (APU) Generator

3)Standby Generator

Part 2

Carrier 21

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Air-cooled, Prepackaged Automatic Standby Generators Introduction ContentsOperation and Maintenance HOW to Obtain ServiceIntroduction General Hazards Safetyrules Important Safety InstructionsStandards Index Important Safety Instructions SafetyrulesProtection Systems 12 ARC Fault Circuit Interrupter ProtectionUNPACKING/INSPECTION Gfci GeneratorGenerator SpecificationsSystem SET LED Fuel RequirementsLifting the Generator Transfer SwitchFuel Consumption AUTO/OFF/MANUAL Battery InstallationBattery OFF Position BREAK-IN ProcedureUsing the AUTO/OFF/MANUAL Switch Figure Auto Position2 120 VAC Gfci Outlet 1 12 Vdcaccessory OutletAutomatic Transfer Operation Sequence of Automatic OperationManual Transfer Operation Transfer to Generator Power SourceTransfer Back to Utility Power Source Over Crank LOW OIL Pressure SwitchHigh Temperature Switch FusesEngine OIL Recommendations OIL Change ProcedureChecking the Engine OIL Level Changing the Engine OIL1 7 KW, 12 Kwand 15 KW Generators Changing the Engine AIR CleanerChanging the OIL Filter Spark PlugsAUTO/OFF/MANUAL switch is set to Battery MaintenanceCorrosion Protection OUT of Service ProcedureRemoval from Service Return to ServiceProcedure Frequency Service ScheduleService Problemcausecorrection Troubleshooting GuideWarranty CarrierAir-cooled 7 EW, 12 EW and 15 EW Generators 21 ! Murphy Drive Generac Power SYSTEMS, INCEmission Related Parts Include the Following Emission Control System WarrantyCatalog NO. OMASPAS07-2

ASPASICCA007, ASPASICCA015, ASPASICCA012 specifications

Carrier, a global leader in heating, ventilating, and air conditioning (HVAC) solutions, has consistently made strides in innovation and efficiency with its range of products. Among its notable offerings are the ASPASICCA012, ASPASICCA015, and ASPASICCA007 air conditioning units. These models exemplify cutting-edge technology, designed to meet diverse cooling needs while prioritizing energy efficiency and user comfort.

The ASPASICCA012 model is tailored for small to medium-sized spaces, providing effective cooling with a capacity of 12,000 BTU. This unit is equipped with advanced inverter technology, allowing it to adjust its compressor speed according to the room's cooling requirements. As a result, it operates more efficiently, consuming less energy while maintaining a stable temperature. Additionally, the ASPASICCA012 features a quiet operation design, making it an ideal choice for bedrooms and offices.

For slightly larger areas, the ASPASICCA015 model offers a cooling capacity of 15,000 BTU. It shares similar technological advancements with the ASPASICCA012, including inverter technology and energy efficiency. However, it can handle higher thermal loads, making it suitable for larger living spaces or commercial applications. The ASPASICCA015 also includes user-friendly controls and smart connectivity options, allowing users to operate the unit remotely via mobile apps.

The ASPASICCA007 is another standout model, aimed at providing an energy-efficient solution for compact spaces with a cooling capacity of 7,000 BTU. It utilizes eco-friendly refrigerants, reducing its carbon footprint while ensuring optimal cooling performance. This model emphasizes quiet operation and includes a sleep mode function that gradually adjusts the temperature to enhance comfort during nighttime.

All three models incorporate features such as a programmable timer, multiple fan speeds, and a self-cleaning function to enhance user experience and maintain air quality. Moreover, Carrier’s commitment to sustainability is evident in each unit’s design, which minimizes energy consumption and leverages environmentally friendly refrigerants.

In summary, the Carrier ASPASICCA series, encompassing models 012, 015, and 007, reflects the company’s dedication to innovation, energy efficiency, and user comfort. Whether it’s a small bedroom or a larger commercial space, these air conditioning units provide reliable cooling solutions tailored to a variety of needs while supporting environmental sustainability.
Top Page Image Contents