APC SMT1500, SUM1500RMXL2U Configuration, UPS Settings, Start-up Settings, General Settings

Page 10

Configuration

UPS Settings

Start-up Settings

Configure these settings at initial start-up, using the display interface or APC PowerChute® software.

Note: During start-up, use the display interface to configure these settings. If nothing is selected, the until will use the default settings.

Function

Factory Default

Options

Description

 

 

 

 

Language

English

• English

The language for the display interface.

 

 

• French*

*Language options will vary by model.

 

 

• German*

 

 

 

• Spanish*

 

 

 

• Italian*

 

 

 

 

 

Local Power

Good

• Good

Select the quality of input utility power.

Quality

 

• Fair

• If Good is selected, the unit will go on battery

 

 

• Poor

power more often to provide the cleanest power

 

 

 

supply to the connected equipment.

 

 

 

• If Poor is selected, the UPS will tolerate more

 

 

 

fluctuations in power and will go on battery power

 

 

 

less often.

 

 

 

If unsure of the local power quality, select Good.

 

 

 

 

Menu Type

Standard

Standard or

The advanced menus include all parameters. The

 

 

Advanced

Standard menus display a limited set of menus and

 

 

 

options.

 

 

 

 

Display

Always On

Always On or

The display may be always on or may be set to

Mode

 

Power Saving

automatically turn on only when using the

 

 

 

configuration buttons or if an event occurs.

General Settings

Configure these settings at any time, using the display interface or APC PowerChute® software.

Function

Factory Default Options

Description

High Transfer

120

V:

• 127 Vac

Point

127

Vac

• 130 Vac

 

 

 

• 133 Vac

 

 

 

• 136 Vac

 

 

 

 

 

230

V:

• 253 Vac

 

253

Vac

• 257 Vac

 

 

 

• 261 Vac

 

 

 

• 265 Vac

To avoid unnecessary battery usage, set the transfer point higher if the utility voltage is chronically high and the connected equipment is known to work under this condition. The POWER QUALITY setting will automatically change this setting.

Note: Use the Advanced Menus to configure this setting.

Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac Tower

7

Image 10
Contents Smart-UPSUPS Contents Smart-UPS Factory Warranty Product Description SafetyOverview Product Overview1000/1500 VA 120 Vac 750 VA 120 Vac Rear panels1000/1500 VA 230 Vac Environmental Specifications SpecificationsInstallation Operating ConditionsOperation Rear Panel FeaturesConnect Equipment to the UPS Overview Using the display interfaceDisplay Interface Standard menusAdvanced menus Start-up Settings ConfigurationUPS Settings General SettingsBattery Self Low BatteryBattery Replacement Audible Alarm SettingMain Outlet Group and the Switched Outlet Group Using the Main Outlet Group and the Switched Outlet GroupNetwork Management Card Settings Normally open contacts Emergency Power OffEPO Overview Normally closed contactsDisplay interface indicators flash sequentially TroubleshootingUPS does not provide expected backup time UPS is emitting an audible beeping soundReplace battery indicator is illuminated Problem and Possible CauseDisplay interface has a Site Wiring Fault message Service and Support ServiceTransport the unit APC Worldwide Customer SupportSmart-UPS Factory Warranty Limited WarrantyDirectives Type of Equipment Harmonized StandardsApplicable Council Model Numbers990-3534-001 06/2009