APC SUM1500RMXL2U, SMT1500 Operation, Connect Equipment to the UPS, Rear Panel Features

Page 7

Operation

Connect Equipment to the UPS

Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do not expect full battery run capability during this initial charge period.

1.Connect equipment to the outlets on the rear panel of the UPS. Do not use extension cords, plug equipment directly into the UPS.

2.Connect the UPS to the building utility power. Connect the UPS to a two-pole,three-wire, grounded receptacle only.

3.Press the ON/OFF button on the front panel of the UPS to apply power to the unit and all connected equipment.

4.To use the UPS as a master on/off switch, turn on all the equipment that is connected to the UPS.

See “UPS Settings” on page 7 for information on how to configure the outlet groups.

su0441a

Rear Panel Features

Serial port: Connect to a computer to use power management software.

USB port: Connect to a computer to use power management software.

Ground Screw: Connect the ground leads on transient voltage devices to the chassis ground screw(s), located on the rear panel of the UPS.

4

Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac Tower

Image 7
Contents Smart-UPSUPS Contents Smart-UPS Factory Warranty Product Overview SafetyOverview Product Description1000/1500 VA 120 Vac 750 VA 120 Vac Rear panels1000/1500 VA 230 Vac Operating Conditions SpecificationsInstallation Environmental SpecificationsOperation Rear Panel FeaturesConnect Equipment to the UPS Standard menus Using the display interfaceDisplay Interface OverviewAdvanced menus General Settings ConfigurationUPS Settings Start-up SettingsSetting Low BatteryBattery Replacement Audible Alarm Battery SelfUsing the Main Outlet Group and the Switched Outlet Group Main Outlet Group and the Switched Outlet GroupNetwork Management Card Settings Normally closed contacts Emergency Power OffEPO Overview Normally open contactsUPS is emitting an audible beeping sound TroubleshootingUPS does not provide expected backup time Display interface indicators flash sequentiallyReplace battery indicator is illuminated Problem and Possible CauseDisplay interface has a Site Wiring Fault message Service Service and SupportAPC Worldwide Customer Support Transport the unitLimited Warranty Smart-UPS Factory WarrantyModel Numbers Harmonized StandardsApplicable Council Directives Type of Equipment990-3534-001 06/2009