PowerBOSS™ | 5600W Portable Generator | ASSEMBLY |
|
|
|
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
Unpack the Generator
1.Set the carton on a rigid flat surface.
2.Remove everything from carton except generator.
3.Open carton completely by cutting each corner from top to bottom.
4.Leave generator on carton to install wheel kit.
Carton Contents
Check all contents against those listed below:
•Main unit
•Engine oil
•Operator’s manual
•Engine operator’s manual
•Wheel kit
If any parts are missing or damaged, call the generator helpline at
Install Wheel Kit
NOTE: Wheel kit is not intended for
•2 - 13mm wrenches
•Socket wrench with a 13mm socket
•Pliers
•Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1.Tip generator so that engine end is up.
2.Slide axle through both mounting brackets.
3.Place a wheel on each side with raised hub inboard.
4.Place a washer on axle and then place an
5.Install
CAUTION
• Always wear eye protection when installing/removing
Figure 1 — Install Wheel Kit
Capscrew |
|
|
Nut |
|
|
Handle |
| Wheel |
|
| |
|
| Washer |
| Axle |
|
Mounting Leg | Capscrew |
|
| ||
|
| |
| Nut |
|
| 6 |
|