THIS UNIT CAN POWER THE FOLLOWING ITEMS
ITEM | RUNNING |
|
| WATTS | WATTS |
1 HP Air Compressor | 1600 | 4500 |
Belt Sander | 1200 | 2400 |
Pressure Washer | 1200 | 3600 |
Refrigerator/Freezer | 700 | 2200 |
1/2 HP Sump Pump | 1050 | 2150 |
1/2 HP Well Pump | 1000 | 2100 |
Miter Saw | 1650 | 3000 |
1400 | 3100 | |
Motor |
|
|
Central | 5000 | 6500 |
10” Table Saw | 1800 | 4500 |
Note: Wattages listed above are estimates. Check nameplate wattages on all loads before connecting to Generator.
OPERATING INSTRUCTIONS
1.Check to make sure the Engine Switch (2) is in its “OFF” position.
(See Figure A.)
2.IMPORTANT: Make sure to unplug any load from the Generator before starting to prevent permanent damage to any appliances, tools, or equipment.
3.Turn the Engine Fuel Valve (41) to its “OPEN” position. Then turn the Engine Choke Lever (21A) to its “CHOKE” position. No choke is required if the Engine is warm. Make sure the Choke Lever is in the “RUN” position when starting a warm Engine. (See Figure F.)
4.To start the Engine, using the Battery (45) for cranking power, insert the Engine Switch Key into the Engine Switch (2). Then turn the Key to the “START” position. NOTE: To prolong Starter life, use short starting cycles (5 seconds maximum). Then wait one minute before attempting to start again. (See Figure A.)
5.To start the Engine manually, using the Starter Handle (41A), insert the Engine Switch Key and turn the Key to its “RUN” position. Grasp the Starter Handle, and pull slowly until resistance is felt. Allow the Starter Rope to rewind slowly. Then, pull the Starter Handle with a rapid, full arm stroke. Allow the Rope to rewind slowly. If necessary, repeat this procedure until the Engine starts.
6.When the Engine starts, slowly move the Choke Lever (21A) to its “RUN” position.
(See Figure F.)
7.IMPORTANT: Allow the Generator to run at no load for five minutes after each
SKU 66603 | For technical questions, please call | Page 14 |