Simplicity 1694383 319E Operation, Fuel and OIL Mixture, Proper Fuel Mixing Procedure

Page 13

FUEL AND OIL MIXTURE

The snowthrower uses a two cycle engine that requires a mixture of fuel (gasoline) and oil for lubrication of engine bearings and other moving parts.

The correct fuel/oil mixture ratio is 50 to 1. Use fuel/oil mixture chart shown.

NOTE: To prevent damage to engine, carefully observe recommended fuel to oil mixing ratio and procedures.

Gasoline and oil must be premixed in a clean fuel container.

Always use fresh, unleaded, winter grade fuel

Never put plain, unmixed fuel into fuel tank. Shake fuel container each time before filling fuel tank.

Never use “stale” fuel left over from last season or stored for long periods.

DO NOT USE MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.

PROPER FUEL MIXING PROCEDURE

1.Fill approved clean fuel container one quarter full with fresh unleaded fuel - one quart (one liter) in a one gallon (4 liter) container.

2.Pour recommended amount of high quality two cycle oil — 2.5 ounces (80 ml) into fuel container for one gallon (4 liters) of fuel. (NOTE: DO NOT USE

MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.)

3.Reinstall cap on the fuel container and shake con- tainer vigorously so oil mixes with gasoline.

4.Unscrew cap and fill container with fuel. Shake con- tainer again.

5.Remove fuel tank cap and carefully pour mixed fuel into the fuel tank, filling to 1/2 inch (1.5 cm) below filler neck to allow room for expansion. Never put plain, unmixed fuel into fuel tank. Shake fuel con- tainer each time before filling fuel tank.

Operation

WARNING

Gasoline is highly flammable and must be handled with care. Follow these fuel handling precautions:

Use an approved fuel container.

DO NOT run the unit indoors. DO NOT fill fuel tank indoors or while engine is running.

Allow engine to cool for at least ten minutes before refueling.

Wipe up any spilled fuel before starting the engine.

Fuel vapors can travel to distant ignition sources. Keep fuel and fuel vapors away from ignition sources.

FUEL TO OIL MIXTURE CHART (50:1)

U.S.

Imperial

Metric

Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil

Gallons

Ounces

Gallons

Ounces

Liters

Milliliters

1

2.5

1

2.8

4

80 ml

2

5

2

5.6

8

160 ml

5

13

5

14.1

20

400 ml

A

B

 

C

 

D

Figure 1. Proper Fuel Mixing Procedure

A.Fill Container with 1 Quart (1 Liter) of fuel

B.2.5 Ounces (80 ml) of two-cycle oil

C.Combine in container, then shake container

D.Additional fuel brings total to 1 Gallon (4 liters)

9

Image 13
Contents Operator’s Manuals Print Vendor InstructionsPage 319E Models 319M ModelsPage Table of Contents General Operation Safety Rules & InformationSlope Operation Do NotService and Maintenance Safety RulesChildren EmissionsAnsi B71.3-1995 Warnings Maintenance and StorageTraining PreparationSafety Decals Safety Decals / Identification NumbersIdentification Numbers Control Locations Features ControlsAll Models Electric Start Features & Controls Checks Before Each START-UP OperationOperational Warnings Operation Proper Fuel Mixing ProcedureFuel and OIL Mixture Multi Viscosity OILS, Such AS 10W-30 or 10W-40Stopping the Engine Starting the EngineSnowthrowing Tips Operating the SnowthrowerStorage Regular Maintenance Troubleshooting Troubleshooting Adjustments, & ServiceProblem Probable Cause Corrective Action Auger Control Adjustment Troubleshooting, Adjustments, & ServiceAdjustment InspectionAuger Drive Belt Idler Pulley Adjustment Troubleshooting, Adjustments, & ServiceEqual Clearance Auger Drive Belt ReplacementAlign Angled Ends Auger Flite Shoe ReplacementReplacement Parts SpecificationsMaintenance Items Technical Manuals