![](/images/new-backgrounds/1068617/6861787x1.webp)
10)Turn on the power supply for 2 minutes.
11)Turn off the power supply.
12)Remove the front panel.
13)Repeat steps 22 through 36 in "Cleaning Procedure – Icemaker" two times to rinse thoroughly.
14)Move the control switch to the ICE position, then proceed to "3. Cleaning Procedure
–Bin".
3.Cleaning Procedure – Bin
1)Dilute approximately 5 fl. oz. of recommended cleaner Hoshizaki "Scale Away" or
2)Make sure that the power supply is off.
3)Remove the grill and chute from the front panel.
4)Remove the shutter and spout extension as follows:
a.Remove the snap pin fitted to the shutter shaft. Shift the shaft to the left, pull out the right side and slide out.
b.Remove the four thumbscrews securing the spout extension and remove the spout extension.
5)Remove the two thumbscrews securing the bin control assembly to the bin cover. Note the orientation of the stainless steel bracket, then remove the bin control and bracket from the bin cover. Carefully remove the bin control paddle from the bin control body.
6)Scrub the inside of the bin, the agitator, the bin spout, the spout extension, the shutter, the front panel spout, the grill, the chute, the bin cover, and the bin control assembly using a nylon scouring pad, brushes and cleaning solution.
7)Rinse all parts thoroughly with clean water, then proceed to "4. Sanitizing Procedure
– Bin". | Bin Control |
|
| |
|
|
| ||
4. Sanitizing Procedure – Bin | Connector |
|
|
|
Thumbscrew |
| Bin |
| |
|
|
| ||
1) Dilute approximately .5 fl.oz.of |
|
|
| |
|
|
|
| |
a 5.25% sodium hypochlorite |
|
|
|
|
solution (chlorine bleach) with |
|
|
|
|
1 gallon of warm water. | Bin Cover |
| Agitator |
|
|
|
| ||
2) Wash all parts from step 6 of |
|
| Snap Pin |
|
"Cleaning Procedure – Bin" |
|
|
| |
|
|
|
| |
with the sanitizing solution. |
|
| Shutter |
|
3) Rinse all parts thoroughly | Chute | Connector |
|
|
with clean water. |
|
| ||
|
|
|
| |
4) Reassemble all parts in the |
| Control |
|
|
reverse order of the removal |
|
|
| |
| Box |
|
| |
procedure. |
| Front |
|
|
| Panel |
| Bin Spout | |
|
| Spout |
| |
5) Turn on the power supply. |
| Thumbscrew |
| |
| Grill | Spout | ||
|
|
| ||
6) Check for proper operation. |
|
|
| Extension |
|
|
|
|
44