![](/images/new-backgrounds/1068617/6861783x1.webp)
VI. Cleaning and Maintenance Instructions
IMPORTANT
Ensure all components, fasteners and thumbscrews are securely in place after any maintenance or cleaning is done to the equipment.
A. Cleaning Instructions
To clean the machine, perform the cleaning and sanitizing procedures for the icemaker and bin in the order in which they appear below.
WARNING
1.Hoshizaki recommends cleaning this unit at least once a year. More frequent cleaning, however, may be required in some existing water conditions.
2.To prevent injury to individuals and damage to the icemaker, do not use ammonia type cleaners.
3.Always wear
1.Cleaning Procedure – Icemaker
1)Dilute approximately 10.5 fl. oz. of recommended cleaner Hoshizaki "Scale Away" or
2)Remove all ice from the evaporator and the bin.
Note: To remove cubes on the evaporator, turn off the power supply and turn it on after 3 minutes. The defrost cycle starts and the cubes will be removed from the evaporator.
3)Turn off the power supply.
4)Remove the front panel and disconnect the connector from the control box.
5)Move the control switch on the control box to the SERVICE position. Then move the service switch to the DRAIN position.
6)Replace the front panel in its correct position.
7)Turn on the power supply for 2 minutes.
8)Turn off the power supply.
9)Remove the front panel.
10)Disconnect the bin control connector. Remove the three thumbscrews securing the bin cover, and remove the bin cover with the bin control attached.
11)Pour the cleaning solution into the water tank.
12)Move the service switch to the WASH position.
13)Replace the front panel in its correct position.
Bin Control
Connector
Thumbscrew | Bin |
|
Bin Cover
Connector
Control
Box
Front
Panel
14) Turn on the power supply, and start the |
|
washing process. | 42 |
|