e) Other
Problem | Possible Cause |
| Remedy |
|
|
|
|
[1]Icemaker will not stop | a) Bin Control | See "II.C.4. Bin Control Troubleshooting." | |
when bin is filled with |
|
|
|
ice. |
|
|
|
|
|
|
|
| b) Control Board | 1. Defective. | 1. See "II.C.5. Control Board |
|
|
| Check Procedure." |
|
|
|
|
[2] Abnormal noise. | a) Pump Motor | 1. Bearings worn out. | 1. Replace |
| b) Fan Motor | 1. Bearings worn out. | 1. Replace |
|
| 2. Fan blade deformed. | 2. Replace fan blade. |
|
| 3. Fan blade does not | 3. Replace. |
|
| move freely. |
|
|
|
|
|
| c) Compressor | 1. Bearings worn out or | 1. Replace. |
|
| cylinder valve broken. |
|
|
|
|
|
|
| 2. Mounting pad out of | 2. Reinstall. |
|
| position. |
|
|
|
|
|
| d) Refrigerant Lines | 1. Rub or touch other | 1. Replace. |
|
| lines or surfaces. |
|
|
|
|
|
[3]Ice in storage bin | a) Drain Line(s) | 1. Plugged. | 1. Clean. |
often melts. | b) Icemaker and Bin | 1. Drains not run | 1. Separate the drain lines. |
| |||
|
| separately. |
|
|
|
|
|
| c) Ice Cube Guide | 1. Out of position. | 1. Place in position. |
|
| Circulated water falls |
|
|
| into bin. |
|
|
|
|
|
2. Dispensing
Problem | Possible Cause |
| Remedy |
[1] No ice dispensed. | a) Power Supply | 1. OFF position. | 1. Move to ON position. |
|
|
|
|
|
| 2. Loose connection. | 2. Tighten. |
|
|
|
|
|
| 3. Bad contacts. | 3. Check for continuity and |
|
|
| replace. |
|
| 4. Voltage too high. | 4. Check and get |
|
|
| recommended voltage. |
| b) Fuse (Inside Fused | 1. Blown. | 1. Check for short circuit |
| Disconnect, if any) |
| and replace. |
|
|
|
|
| c) Dispense Switch | 1. Connector from front | 1. Connect. |
|
| panel not connected |
|
|
| to control box. |
|
|
|
|
|
|
| 2. Bad contacts. | 2. Check for continuity and |
|
|
| replace. |
|
|
|
|
|
| 3. Loose connection. | 3. Tighten. |
|
|
|
|
| d) Gear Motor | 1. Thermal protector is | 1. Allow to cool. |
|
| tripped. |
|
|
| 2. Gear motor winding | 2. Replace. |
|
| opened. |
|
|
| 3. Bearing worn out. | 3. Replace. |
|
|
|
|
30
