Simplicity 1693649 755M Starting Controls, Units with Optional Electric Start, Manual Start

Page 10

Controls

STARTING CONTROLS

Units with Optional Electric Start

A.Electric Start Button - The Electric Start Button

(A, Figures 4 & 5) activates an electric starter mount- ed to the engine, eliminating the need to pull the starter handle. The Electric Start Button operates on 120 Volts AC, which is provided by connection to the extension cord provided with units equipped with this feature. Connect this extension cord ONLY to a properly grounded 3 prong electrical outlet.

Manual Start

B.Fuel Valve - The fuel valve (B, Figure 4 & 5) is locat- ed under the fuel tank. It is used to turn the fuel sup- ply off for out-of-season storage.

C.Starter Handle - The starter handle (C, Figure 4 & 5) connects to a starter cord to manually start the engine. Pulling starter handle rapidly spins the engine crankshaft, cycles the engine, and generates the spark necessary for starting the engine.

D.Primer Button - When pressed, the primer button (D, Figure 4 & 5) provides initial fuel to help start a cold engine. Normally, pressing the primer button twice will provide enough fuel to start a cold engine.

E.Throttle Lever - The throttle lever (E, Figure 4 & 5) controls the engine speed. For best overall perfor- mance, the throttle lever should be set to the FAST position. Use the SLOW position only for warming the engine, or to help prevent snow/ice freeze-up when shutting the unit down for the day.

F.Engine Key - The Engine Key (F, Figure 4 & 5) pre- vents the engine from being started by unauthorized individuals. The key must be fully inserted into the key slot for the unit to start. The key is also used to stop the engine by pulling the key out of the key slot.

G.Choke Knob - The Choke Knob (G, Figure 4 & 5) adjusts the air/fuel mixture, and is used to help start a cold engine by providing a richer mixture. Once the engine is warm and running smoothly, the Choke Knob should be set to the off position to provide a normal air/fuel mix.

B

 

A

 

 

C

 

 

D

G

F

E

Figure 4. Engine Controls - 5HP Models

A. Electric Start Button (Optional)

E. Throttle Lever

B. Fuel Valve

F. Engine Key

C. Starter Handle

G. Choke Knob

D. Primer Button

 

 

C

D

 

G

 

F

E

 

Figure 5. Engine Controls - 7HP Models

A*. Electric Start Button (Optional)

E. Throttle Lever

B*. Fuel Valve

F. Engine Key

C. Starter Handle

G. Choke Knob

D. Primer Button

 

*Electric start button & fuel valve located on right side of engine.

6

Image 10
Contents How to use this file...Operators Manuals Simplicity Technical Publications Department at 414This page Intentionally Blank OPERATOR’S Manual ModelsPage Table Of Contents General Safety RulesPreparation Maintenance & Storage OperationSafety Decals Safety Signs & DecalsAdditional Decals Snowthrower Controls Control Reference ChartEngine Controls Units with Optional Electric Start ControlsStarting Controls Manual StartDeflector Controls Ground Speed ControlsAuger Control Scraper Height ControlOperation Checks Before Each START-UPStarting the Engine OperationEngine Speed Operating the SnowthrowerGround Speed Selector ThrottleDeflector Scraper BAR & Skid ShoesKlik-Pin Outer Hole FREE-WHEELING Traction Drive LockAfter Each USE Klik-Pin Inner HoleStarting After Storage Normal CareOFF-SEASON Storage Check Auger Gear Case LubricationDriv e Disc Regular MaintenanceLubrication Friction DiscMaintenance Records Engine fails to start ServiceTroubleshooting Engine starts hard or runs poorlyAuger rotates, but snow is not Scraper bar does not clean hardAuger does not stop when auger Thrown far enoughInitial Adjustment Speed Selector Pivot ADJUST- MentTraction Drive Clutch ROD Adjustment Run-In AdjustmentDrive Belt Adjustment Auger Drive Clutch ROD AdjustmentRelease Auger Control. Auger must stop within 5 seconds Auger Control Checking Auger Belt & Belt Guide AdjustmentsAdjusting Auger Drive Belt Belt CoverTraction Drive Belt Replacement Drive Belts and ReplacementAdjusting Auger Belt Guide Lower Cover Removed For ClarityDrive Belt Replacement Auger Drive Belt ReplacementPins Roller Chain ReplacementShear PIN Replacement Keeper linkDischarge Chute Worm Assembly Adjustment Checking Tire PressureEngine Auger HousingOverall Dimensions & Weight DriveAccessories Common Replacement PartsTechnical Manual Availability