Troubleshooting, Adjustments, & Service

Lift Adjustment

In the fully raised position the attachment should be 4”-5” off the ground. In the fully lowered position, the lift rod should compress the spring creating downward pressure on the snowthrower.

NOTE: Always adjust the lift height before and after adjusting the downward pressure.

LIFT HEIGHT ADJUSTMENT

1.Fully raise the attachment lift. The snowthrower should be approximately 4”-5” off the ground. If not, go to step 2.

2.Lower the snowthrower and adjust the front set collar (A, Figure 9) to achieve the correct lift height.

DOWNWARD PRESSURE ADJUSTMENT

NOTE: Check that the lift bar or lock plate (Figures 14 & 15) are in the correct positions

1.Place the lift in the fully raised position.

2.Release the rear set collar (C, Figure 9).

3.Slide the set collar (C) forward until it is slightly com- pressing the spring. Tighten the set collar screw. Do not over-compress the lift rod spring.

LIFT ASSIST ADJUSTMENT (MANUAL LIFT ONLY)

Figure 9. Adjusting Lift Rod

A.Front Set Collar

B.Spring

C.Rear Set Collar

1.Tighten the lift assist bolt (A, Figure 10) to increase the amount of lift assist.

IMPORTANT NOTE

DO NOT OVER-COMPRESS THE SPRING. In addition to providing downward pressure, the spring is an elastic medium that absorbs shocks caused by bumps and cracks in ground surfaces. Over-compressing the spring defeats this and may cause damage to the unit.

Snapper 1694874, 1724089, 1695099, 1694238 Troubleshooting, Adjustments, & Service, Lift Adjustment