General Operating
Instructions
WARNING | WARNING |
If auger does not start and stop when engaging/disengaging electric clutch, see your authorized dealer. Under no circumstances should you attempt to defeat the safety system.
Checks Before Starting
IMPORTANT NOTE: Refer to Tractor Operator’s Manual for important information concerning safely storing your tractor.
1.Refer to the Maintenance & Adjustments sections of this manual and perform any needed service. Also, refer to the tractor Operator’s Manual and perform any required service.
2.Remove any objects from the work area which might be caught in, or thrown by, the auger.
3.Before starting the engine, clear the auger of any ice particles which may cause damage to auger.
4.Adjust the deflector and skid shoes to desired height. See Skid Shoe Adjustment and Deflector Adjustment.
5.Make sure all hardware is present and secure.
Engine & Ground Speed Selection
Always run the engine at full throttle.
Normally, a slow ground speed is best for throwing snow. The deeper or heavier the snow, the slower the recom- mended ground speed.
Starting & Stopping
1.Start the tractor engine. Set engine throttle FULL.
2.Lower the snowthrower.
3.Engage the electric clutch switch. Snowthrower auger should rotate. Disengage the electric clutch switch. Snowthrower auger should stop.
4.Adjust the throttle to full speed. Select the proper ground speed.
5.To stop tractor movement, depress the clutch/brake pedal. To stop the snowthrower, disengage the elec- tric clutch. Before leaving the seat, disengage the electric clutch, set the parking brake, stop the engine, remove the key, and wait for all moving parts to stop.
Perform the Safety System Interlock test found in your tractor Operator’s Manual. If tractor does not pass the test, do not operate the tractor. See your authorized dealer. Under no circumstances should you attempt to defeat the safety system.
Use caution when clearing a snow covered area. Snow can cover objects such as curbs,
To prevent an explosion or fire, never store the tractor with fuel in the tank inside a building where an ignition source is present.
IMPORTANT NOTE
Always raise the snowthrower before turning or backing up to prevent damage to the unit.
DANGER
OPERATING ON SLOPES CAN BE DANGEROUS
Never operate on slopes greater than 17.6% (10°) which is a rise of
Operate the unit at a slow ground speed when driving onto slope. Avoid using brakes to control ground speed.
When operating on slopes that are greater than 15 % (8.5°) but less than 17.6%, use additional wheel weights or counterweights.
In addition to counterweights, use extra caution when operating on slopes. Drive UP and DOWN the slope, never across the face, use caution when changing directions and DO NOT START OR STOP ON SLOPE.
For additional traction, tire chains and a weight box can be added. Maximum weight added to tractor should not exceed 50 lbs. per wheel and 100 additional lbs. in weight box.
Transporting
1.Disengage the electric clutch and then raise the snowthrower.
2.Adjust ground speed according to surface conditions.
3.Select a low ground speed when transporting on a slippery surface.
7