Snapper 1694874, 1724089, 1695099 Install Skid Shoes, Attach Deflector Control Cable Support Arm

Initial Setup & Assembly

			B
				A
	B	C
		E
		F	C
A	D		Figure 19. Deflector Control Cable Support Arm
Figure 18. Skid Shoe Installation			A. Support Arm
			B. 5/16-18 x 1 Carriage Bolt
A. Carriage Bolt, 3/8-16 x 3/4”
			C. Lockwasher & Nut
B. Snowthrower Housing
C. Skid Shoe
D. Washer			G	H
E. Lockwasher
F. Hex Nut			F

Install Skid Shoes

1.Install the skid shoes using 3/8-16 x 3/4” carriage bolts, washers, lockwashers, and nuts as shown in

Figure 18.

2. Adjust the skid shoes. See Adjustments section.

Attach Deflector Control Cable Support Arm

1. Assemble the deflector control cable support arm (A,	E
Figure 19) to the left side of the snowthrower using
one 5/16-18 x 1” carriage bolt (B), lockwasher, and
nut (C) using the holes shown.

Install Chute Rotator Switch and Harness	A
1. Remove the plug from the switch mounting hole in
	D
the right side of the dashboard.

2. Route the switch harness (C, F, Figure 20) through the frame and dashboard as shown.

3. Install the switch (G) in the dashboard and connect the upper end of the switch harness (F) to it.

C

4.	Connect the red/yellow power lead (H) to the red/yel-	B
	low tractor harness lead (E). Connect the black	Figure 20. Install Power Port & Switch
	power lead to the black tractor harness lead.
5.	Mount the trailer plug socket (B) in the frame at loca-	A. Rotator Motor Harness
		B. Trailer Plug
	tion (D). Connect the trailer plug lead (B) to the lower
		C. Switch Harness Lower Plug
	switch harness connector (C).
		D. Plug Hole (Frame)
6.	Do not connect the snowthrower wire harness (A) at	E. Tractor Harness Leads
	this time.	F. Switch Harness Upper Plug
		G. Switch
		H. Power Leads

17