Removal &
Normal Installation
|
|
| G |
A | B | H | G |
| |||
|
| ||
F | C |
|
|
|
|
| |
|
|
| E |
|
|
| D |
Figure 33. Removal |
|
|
A. Rotator Motor Plug | E. Clevis Pin & Clip | H. RH Lift Lever |
B. Lift Rod | F. Assist Spring & | Assembly |
C. Hair Pin Clip | Anchor |
|
D. Hitch Pin & Clip | G. Clevis Pin & Hair Pin |
|
Removal
1.Fully raise and support the snowthrower with wood blocks.
2.Manual Lift Models: Release and remove the lift assist spring and anchor (F, Figure 33).
3.Lower the snowthrower.
4.Remove the clevis pin and clip (E) from the remote deflector control and disconnect the control from the mounting bracket.
5.Disconnect the rotator motor plug (A).
6.Disconnect the rear of the lift rod (B) from the lift arm extension. Remove the hair pin clip (C) from the front of the lift rod. Remove the lift rod. Remove the lift arm extension from the tractor (see Hitch Installation Instructions).
7.Use the trunnion handle (C, Figure 34) to relieve belt tension. Remove the belt from the snowthrower drive pulley (A, Figure 35).
22