Snapper 8526, 9528, 10530, 11532 manual North American Model Decals

Page 7

Decals

DECALS

This unit has been designed and manufactured to pro- vide you with the safety and reliability you would expect from an industry leader in outdoor power equipment.

Although reading this manual and safety instructions it contains will provide you with the necessary basic knowl- edge to operate this equipment safely and effectively, we have placed several safety labels on the unit to remind you of this important information while you are operating your unit.

All WARNING, CAUTION, and instructional messages on your unit should be carefully read and obeyed. Personal bodily injury can result when these instructions are not followed. The information is for your safety and it is important.

The safety decals below are on your unit.

If any of these decals are lost or damaged, replace them at once. See your local dealer for replacements.

These labels are easily applied and will act as a constant visual reminder to you, and others who may use the equipment, to follow the safety instructions necessary for safe, effective, operation.

NOTE: Engine operation and safety decals are supplied by the engine manufacturer.

NORTH AMERICAN MODEL DECALS

Part No. 1733033 - DANGER / WARNING

Main Dash Decal, North American, w/ Easy Turn

Part No. 1733056 - DANGER / WARNING

Main Dash Decal, North American, w/o Easy Turn

WARNING

The lubrication points shown here must be lubricated

with 30 weight oil every 10 hours of operation, and

Required maintenance

before using the unit after storage. Failure to lubricate

may cause a malfunction of the safety system.

1733526

Part No. 1733526

Lubrication Decal

Part No. 728183

Important

DANGER

Amputation hazard

Contact with the auger will cause serious injury.

• Keep hands, feet, and clothing away.

• Shut off engine before servicing.

1716532

Part No. 1716532

Auger Danger

Decal

“V” BELTS STRETCH UNDER NORMAL USE WHICH WILL AFFECT DISCHARGE PERFORMANCE AND SHOULD BE PERIODICALLY ADJUSTED. REFER TO MANUAL FOR INSTRUCTIONS.

DANGER

Amputation hazard

Contact with moving parts inside chute will cause serious injury.

Shut off engine before unclogging discharge chute.

Use clean-out tool, not hands!

1733057

Part No. 1733057

Discharge Chute

Danger Decal

Over Adjustment

Part No. 725432

Belt Stretch &

Adjust

6

Image 7
Contents Models OPERATOR’S ManualTable of Contents Safety Rules & Information Operating Safety Moving Parts Safety Rules and InformationTraining Safety Rules & InformationChildren Safety RulesDecals DecalsNorth American Model Decals CE Model Decals ALL Model DecalsChute Release Shift Decal Safety Icons Safety IconsCE Models Identification NumbersCE Identification TAG Markings North AmericanControl Locations Features, Controls, & OperationSpeed Selector Features & Controls Checks Before Each START-UP OperationElectric Start Starting ControlsManual Start Will Continue until the Free-Hand Control is released Starting the EngineOperating the Snowthrower Clearing a Clogged Discharge ChuteScraper BAR & Skid Shoes Ground Speed SelectorEngine Speed DeflectorEasy Turn Traction Full TractionEasy Turn Freewheeling Traction Drive Lock Storage After Each USEAuger Gear Case Lubrication Regular MaintenanceMaintenance Schedule Checking Tire PressureLubrication Regular MaintenanceCheck / Lubricate FREE-HAND Linkage Lubricating the Auger Shaft & AssemblyLubricate as shown in figure Page Troubleshooting Troubleshooting, Adjustments, ServicePoor traction Auger does not stop when augerAuger rotates, but snow is not Thrown far enoughInitial Adjustment AdjustmentsAuger Drive Adjustment Traction Drive Cable Adjustment16 10.95cm Run-In AdjustmentTraction Drive Belt Easy Turn Cable AdjustmentBelt Adjustment Auger Drive Belt3.18mm Adjustments & ServiceShear PIN Replacement Belt Guide AdjustmentBelt Replacement ServiceSpout Rotator Rod Special Nut Cover Hair Pin Traction Belt Change Swing Plate Alignment Tabs Engine SpecificationsChassis Technical Manuals Parts & AccessoriesReplacement Parts Maintenance ItemsO D U C T S