Tractor Lift Linkage, Hydraulic Lift Models

Tractor Lift Linkage

	Snowthrower
	& Dozer
	Applications
A
B	F
C	F
D	E
	E
	Mower
	Applications
A
B	F
	F
G	E

Figure 28. Lift Lock Plate - Hydraulic Lift Models

A.Lift Cylinder

B.Flat Head Pin (Original)

C.Flat Head Pin (New)

D.Lock Plate

E.Hair Pin Clips

F.Lift Shaft Assy.

G.Washers

LIFT VARIATIONS WHEN USING ATTACHMENTS

When a front-mounted attachment such as a snowthrow- er or dozer blade is used with the tractor, the lift mecha- nism must be locked to provide downward force. When the mower is reinstalled the downward pressure lock must be released so that the mower can float.

Hydraulic Lift Models

When using a snowthrower or dozer, the downward pressure lock plate (D, Figure 28) and an additional pin

(C)is installed. These parts are included with the attach- ment. Note that the washers (G) are not used with the lock plate.

When mowing, the downward pressure lock plate (D) is removed and replaced with two washers (G). The addi- tional pin (C) is also removed.

Fully lower the hydraulic lift. The lift assembly is spring loaded so it will need to be held in the down position to perform of the following procedures.

Snowthrower

& DozerE

Applications

B	C	D
Mower
Applications		G
A

F CD

Figure 29. Lift Link - Manual Lift Models

A.Pin

B.Rear Hole of Lift Bar (Snowthrower Applications)

C.Spacer

D.Hair Pin Clip

E.Upper Hole (Snowthrower Applications)

F.Slot of Lift Link (Mower Applications)

G.Lower Hole (Mower Applications)

Manual Lift Models

NOTE: These instructions apply to Conquest / 1700 / 2700 Series tractors or Broadmoor / 1600 / 2600 Series tractors equipped with a lift lever kit.

The lift link is installed differently depending on what attachment is being used. Refer to Figure 29 for link installation information.