Snapper 1694296, 1694295, 1694144, 1694150 manual Safety Rules & Information

Page 3

Safety Rules & Information

This machine is capable to amputating hands and feet. Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or

bystanders, or damage to property or equipment. The triangle in text signifies important cautions or warnings which must be followed.

TRAINING

1.Read, understand, and follow all instructions on the machine and in the manuals before operating this unit. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

2.Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

3.Keep the area of operation clear of all persons, partic- ularly small children and pets.

PREPARATION

1.Thoroughly inspect the area where the equipment is to be used and remove all doormats, sleds, boards, wires, and other foreign objects.

2.Disengage all clutches and shift into neutral before starting engine (motor).

3.Do not operate the equipment without wearing ade- quate winter outer garments. Avoid loose fitting cloth- ing that can get caught in moving parts. Wear footwear that will improve footing on slippery sur- faces.

4.Handle fuel with care; it is highly flammable.

(a)Use an approved fuel container.

(b)Never add fuel to a running engine or hot engine.

(c)Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors. Replace fuel cap securely and wipe up spilled fuel.

(d)Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place con- tainers on the ground, away from your vehicle, before filling.

(e)When practical, remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such on a trailer with a portable container, rather than from a gasoline dis- penser nozzle.

(f)Keep nozzle in contact with the rim of the fuel tank or container opening at all times, until refueling is complete. Do not use a nozzle lock-open device.

(g)Replace gasoline cap securely and wipe up spilled fuel.

(h)If fuel is spilled on clothing, change clothing imme- diately.

5.Adjust the collector housing height to clear gravel or crushed rock surfaces.

6.Never attempt to make any adjustments while the engine (motor) is running (except when specifically recommended by the manufacturer).

7.Let engine (motor) and machine adjust to outdoor temperatures before starting to clear snow.

8.Always wear safety glasses or eye shields during operation or while performing an adjustment or repair to protect eye from foreign objects that may be thrown from the machine.

TP-600-4159-00-UV-SMAN

OPERATION

1.Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times.

2.Exercise extreme caution when operating on or crossing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic. Do not carry Passengers.

3.After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, disconnect the cord on electric motors, thoroughly inspect the snowthrower for any damage, and repair the damage before restarting and operating the snowthrower.

4.If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

5.Stop the engine (motor) whenever you leave the operating position, before unclogging the collector/impeller housing or discharge guide, and when making any repairs, adjustments, or inspec- tions.

6.When leaving the machine unattended, disengage the power take-off (PTO), lower the attachment, set the parking brake, stop the engine, and remove the key.

7.When cleaning, repairing, or inspecting make certain the collector/impeller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the plug to prevent accidental starting. Do not run the engine indoors except for starting the engine or for transporting the snowthrow- er in or out of the building. Open the outside doors; exhaust fumes are dangerous.

8.Exercise extreme caution when operating on slopes. Do not attempt to clear steep slopes.

9.Never operate the snowthrower without proper guards plates, or other safety protective devices in place and working.

10.Never direct the discharge toward people or areas where property damage can occur. Keep children and others away.

11.Do not overload the machine capacity by attempting to clear snow at too fast a rate.

12.Never operate the machine at high transport speeds on slippery surfaces. Look behind and use care when operating in reverse.

13.Disengage power to the collector/impeller when snowthrower is transported or not in use.

14.Use only attachments and accessories approved by the manufacturer of the snowthrower (such as wheel weights, counterweights, or cabs).

15.Never operate the snowthrower without good visibility or light. Always be sure of your footing, and keep a firm hold on the handles. Walk, never run.

16.Never touch a hot engine or muffler.

17.Never operate the snowthrower near glass enclo- sures, automobiles, window wells, drop-offs, and the like without proper adjustment of the discharge angle.

18.Never direct discharge at bystanders or allow anyone in front of the unit.

19.Never leave a running unit unattended. Always disen- gage the auger and traction controls, stop engine, and remove keys.

2

Image 3
Contents OPERATOR’S Manual Table of Contents Safety Rules & Information Children Safety RulesSafety Decals Safety DecalsTractor Controls Safety InformationRequired Accessories Recommended AccessoriesControl Functions Transporting Checks Before StartingEngine & Ground Speed Selection Starting & StoppingOff-Season Storage General Operating InstructionsSnow Removal Suggestions Daily StorageSchedule For Normal Care General LubricationLubricate Discharge Chute Maintenance Inspect, Adjust, & Lubricate Drive ChainLubricate Auger Bearings Troubleshooting, Adjustments, & Service Electric Chute Rotator Gear Troubleshooting, Adjustments, & ServiceDrive Chain Adjustment Skid Shoe AdjustmentLift Rod Adjustment Troubleshooting, Adjustments, & ServiceBelt Replacement Belt Tension AdjustmentInitial Setup & Assembly Install Skid Shoes Initial Setup & AssemblyInitial Setup & Assembly Install HitchAttach Deflector Control Cable Support Arm Assist Lever Install Chute Rotator Switch and HarnessMount Remote Deflector Control Install Snowthrower Hitch Pin Hair Pin Clip Install SnowthrowerLift Assist Spring Assist Spring Lever C. Spring Bracket Install Drive Belt Removal Removal Normal InstallationNormal Installation Manual Lift Models Lift Variations When Using AttachmentsTractor Lift Linkage Hydraulic Lift ModelsHardware Identification & Torque Specifications Mounting Remote Deflector Control Mounting Remote Deflector ControlTemplate Template