Cub Cadet WE 26 warranty Auger Belt Replacement

Page 15

1

2

3

4

Auger Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed as follows:

1.Remove the plastic belt cover on the front of the engine by removing the two self-tapping screws.

NOTE: Drain the gasoline from the snow thrower, or place a piece of plastic under the gas cap.

2.Carefully pivot the snow thrower up and forward so that it rests on the auger housing. Remove the frame cover from the underside of the snow thrower by removing four self-tapping screws which secure it.

3.Roll the auger belt off the engine pulley.

4.a. Loosen and remove the shoulder screw which acts as a belt keeper.

b.Unhook the support bracket spring from the frame.

5.Remove the belt from around the auger pulley, and slip the belt between the support bracket and the auger pulley. Reassemble auger belt by following instructions in reverse order.

NOTE: Do NOT forget to reinstall the shoulder screw and reconnect the spring to the frame after installing a replacement auger belt.

5

6

Maintaining

Your Snow

Thrower

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi- viscosity oils also result in higher oil consump- tion when used above 32ºF. Check your snow thrower’s engine oil level more frequently to avoid possible engine damage from running low on oil.

NOTE: Do not sand- blast spark plug. Spark plug should be cleaned by scraping or wire brushing and washing with a commercial solvent.

IMPORTANT NEVER replace the auger shear pins with standard pins. Any damage to the auger gearbox or other com- ponents, as a result of doing so, will NOT be covered by your snow thrower’s warranty.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Two-Stage Snow Thrower Model WE OPERATOR’S ManualTable of Contents Finding and Recording Model NumberCustomer Support Your Responsibility Safety LabelsYour Responsibility Restrict the use PracticesYour Responsibility Do not modify engineTighten hand knobs securing upper handle to lower handle Setting Up Your Snow ThrowerChute Clean-Out Tool Shear Pin StorageTire Pressure Know Your Snow Thrower Operating Your Snow ThrowerIgnition Key Clean-Out ToolAuger Control Drive Control/ Auger Control LockElectric Starter Gas & Oil Fill-UpStopping The Engine Starting The EngineTo Engage Drive To Engage AugersAuger Control Test Drive Control Shift Lever Making AdjustmentsShift Cable Chute ControlAuger Control Skid ShoesShave Plate and Skid Shoes Maintaining Your Snow ThrowerEngine LubricationAuger Belt Replacement Augers Drive Belt ReplacementFriction Wheel Removal Short-Term Storage Off-Season StoragePreparing Engine Preparing Snow ThrowerTrouble- shooting This section Addresses minor Service issuesModel WE26 Parts, call the Customer Dealer Referral Line at Parts ListTo order replacement Or visitModel WE26 738-04194 Flange Shoulder Screw 452 26 13 684-04153 Page U.S.A Canada MANUFACTURER’S Limited Commercial Warranty forMANUFACTURER’S Limited Warranty for
Top Page Image Contents