Cub Cadet WE 26 warranty Operating Your Snow Thrower, Know Your Snow Thrower

Page 8

4

Operating

Your Snow

Thrower

WARNING

Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.

Use extreme care when handling gasoline.

Know Your Snow Thrower

 

Drive Control

Shift Lever

 

 

Four-Way

 

 

Chute Control™

 

 

Auger Control

 

Electric Start Button

 

Chute

Gas Cap

 

 

 

Assembly

Oil Fill

 

 

 

Clean-Out Tool

 

Engine Controls

 

Recoil Starter

 

 

 

 

Handle

 

 

Electric Starter Outlet

 

 

Primer

 

 

Ignition

 

 

Key

Choke

Control

Skid Shoe

Throttle

 

Control

Figure 12

Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition.

Now that you have setup your snow thrower, it’s important to become acquainted with its controls and features.

NOTE: For detailed starting instructions and more information on all engine controls, refer to the Tecumseh Engine manual packed separately.

Shift Lever

The shift lever is located on the right side of the handle panel. Place the shift lever into any of eight positions to control the direction of travel and ground speed.

Forward

Your snow thrower has six forward (F) speeds, with position number one (1) being the slowest speed.

Reverse

Your snow thrower has two reverse (R) speeds, with position number one (1) being the slower speed.

Choke Control

The choke control is found on the rear of the engine and is activated by rotating the knob clockwise. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine.

Throttle Control

The throttle control is located on the engine. It regulates the speed of the engine and will shut off the engine when pushed down completely.

Primer

Depressing the primer forces fuel directly into the engine’s carburetor to aid in cold-weather starting.

Oil Fill

Engine oil level can be checked and oil added through the oil fill.

Image 8
Contents OPERATOR’S Manual Two-Stage Snow Thrower Model WECustomer Support Table of ContentsFinding and Recording Model Number Safety Labels Your ResponsibilityPractices Your Responsibility Restrict the useDo not modify engine Your ResponsibilitySetting Up Your Snow Thrower Tighten hand knobs securing upper handle to lower handleTire Pressure Chute Clean-Out ToolShear Pin Storage Operating Your Snow Thrower Know Your Snow ThrowerClean-Out Tool Auger ControlDrive Control/ Auger Control Lock Ignition KeyGas & Oil Fill-Up Stopping The EngineStarting The Engine Electric StarterAuger Control Test To Engage DriveTo Engage Augers Making Adjustments Shift CableChute Control Drive Control Shift LeverSkid Shoes Auger ControlMaintaining Your Snow Thrower EngineLubrication Shave Plate and Skid ShoesAuger Belt Replacement Drive Belt Replacement AugersFriction Wheel Removal Off-Season Storage Preparing EnginePreparing Snow Thrower Short-Term StorageThis section Addresses minor Service issues Trouble- shootingModel WE26 Parts List To order replacementOr visit Parts, call the Customer Dealer Referral Line atModel WE26 738-04194 Flange Shoulder Screw 452 26 13 684-04153 Page MANUFACTURER’S Limited Commercial Warranty for U.S.A CanadaMANUFACTURER’S Limited Warranty for