Cub Cadet WE 26 warranty Augers, Drive Belt Replacement

Page 16

6 1

Maintaining

Your Snow

Thrower

Augers

•The augers are secured to the spiral shaft with two shear pins and cotter pins. If the auger should strike a foreign object or ice jam, the snow thrower is designed so that the pins may shear. Refer to Figure 9.

•If the augers will not turn, check to see if the pins have sheared. One set of replacement shear pins has been provided with the snow thrower. When replacing pins, spray an oil lubricant into shaft before inserting new pins.

Drive Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed as follows:

1.Remove the plastic belt cover on the front of the engine by removing the two self-tapping screws.

NEVER replace the auger shear pins with anything other than OEM Part No.738-04124 replacement shear pins. Any damage to the auger gearbox or other components as a result of failing to do so will NOT be covered by your snow thrower’s warranty.

2

3

•Drain the gasoline from the snow thrower, or place a piece of plastic under the gas cap.

•Carefully pivot the snow thrower up and forward so that it rests on the auger housing.

2.Remove the frame cover from the underside of the snow thrower by removing four self-tapping screws which secure it.

3.a. Grasp the idler pulley and pivot it toward the right.

b.Roll the auger belt off the engine pulley.

c.Lift the drive belt off engine pulley.

4.Slip the drive belt off the pulley and between friction wheel and friction wheel disc.

• Remove and replace belt in the reverse order.

4

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents OPERATOR’S Manual Two-Stage Snow Thrower Model WEFinding and Recording Model Number Table of ContentsCustomer Support Safety Labels Your ResponsibilityPractices Your Responsibility Restrict the useDo not modify engine Your ResponsibilitySetting Up Your Snow Thrower Tighten hand knobs securing upper handle to lower handleShear Pin Storage Chute Clean-Out ToolTire Pressure Operating Your Snow Thrower Know Your Snow ThrowerClean-Out Tool Auger ControlDrive Control/ Auger Control Lock Ignition KeyGas & Oil Fill-Up Stopping The EngineStarting The Engine Electric StarterTo Engage Augers To Engage DriveAuger Control Test Making Adjustments Shift CableChute Control Drive Control Shift LeverSkid Shoes Auger ControlMaintaining Your Snow Thrower EngineLubrication Shave Plate and Skid ShoesAuger Belt Replacement Drive Belt Replacement AugersFriction Wheel Removal Off-Season Storage Preparing EnginePreparing Snow Thrower Short-Term StorageThis section Addresses minor Service issues Trouble- shootingModel WE26 Parts List To order replacementOr visit Parts, call the Customer Dealer Referral Line atModel WE26 738-04194 Flange Shoulder Screw 452 26 13 684-04153 Page MANUFACTURER’S Limited Commercial Warranty for U.S.A CanadaMANUFACTURER’S Limited Warranty for
Top Page Image Contents