SERVICE AND MAINTENANCE
Figure 24
See Figure 26.
NOTE: Make sure that the location of the ferrule on the auger idler rod is maintained.
2.Slip the auger control belt (the front belt) off the engine pulley.
3.Pull the brake bracket assembly towards the cable guide roller and unhook the auger cable “Z” fitting. See Figure 27.
4.From both sides of the the frame assembly, use a 1/2” wrench to remove the three hex tap screws securing the frame to the auger housing assembly. Refer to Figure 23 on previous page.
NOTE: Do not remove the lower hex flange lock nut on each side.
5.Place a block of wood underneath the auger housing as shown in Figure 28 and separate auger housing from the frame by tilting the housing forward and pulling up the handles.
6.Block the impeller with a piece of wood to prevent it from spinning and use a 1/2” wrench to remove the hex screw and flat washer from the center of the pulley on the auger housing. See Figure 29.
7.Lift the brake bracket assembly out of the pulley groove and slide the pulley assembly off the posts of the auger pulley adapter to remove the old belt. Refer to Figure 29.
NOTE: The pulley adapter may slide off the auger input shaft when removing the pulley. Use extra caution to ensure the adapter does fall and/or get damaged when removing the pulley.
8.Place the new auger belt in the
9.Turn the pulley as necessary to align its three slots approximately with the posts of the pulley adapter, then move the brake bracket assembly away from the input shaft. While aligning the pulley slots and adapter posts, push the auger pulley fully onto the adapter. Refer to Figure 29.
NOTE: If the pulley adapter was removed with the pulley, align the splines of the pulley adapter and auger input shaft, and push the pulley and adapter onto the input shaft. Refer to Figure 29.
10.Slide the washer onto the hex screw removed earlier and apply Loctite 262 to the threads of the hex screw.
11.Insert the hex screw through the pulley assembly and into the
Remove
Loosen
Figure 25
Figure 26
Figure 27
20