Craftsman 247.88845 manual This page applicable in the U.S.A. and Canada only

Page 36

(This page applicable in the U.S.A. and Canada only.)

Sears, Roebuck and Co., U.S.A. (Sears), the California Air Resources Board (CARB)

and the United States Environmental Protection Agency (U.S. EPA)

Emission Control System Warranty Statement (Owner’s Defect Warranty Rights and Obligations)

EMISSION CONTROL WARRANTY COVERAGE IS APPLICABLE TO CERTI- FIED ENGINES PURCHASED IN CALIFORNIA IN 1995 AND THEREAF- TER, WHICH ARE USED IN CALIFORNIA, AND TO CERTIFIED MODEL

YEAR 1997 AND LATER ENGINES WHICH ARE PURCHASED AND USED ELSEWHERE IN THE UNITED STATES (AND AFTER JANUARY 1, 2001 IN CANADA).

California and United States Emission Control Defects Warranty Statement

The California Air Resources Board (CARB), U.S. EPA and Sears are pleased to explain the Emission Control System Warranty on your model year 2000 and later small off-road engine (SORE). In California, new small off-road engines must be designed, built and equipped to meet the State’s stringent anti-smog standards. Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later must meet similar standards set forth by the U.S. EPA. Sears must warrant the emission control system on your

engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off-road engine.Your emis- sion control system includes parts such as the carburetor, air cleaner, ignition system, muffler and catalytic converter. Also included may be connectors and other emission related assemblies. Where a warrantable condition exists, Sears will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Sears Emission Control Defects Warranty Coverage

Small off-road engines are warranted relative to emission control parts defects

part on your engine is defective, the part will be repaired or replaced by Sears.

for a period of one year, subject to provisions set forth below. If any covered

 

Owner’s Warranty Responsibilities

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instruc- tions. Sears recommends that you retain all your receipts covering maintenance on your small off-road engine, but Sears cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should however be aware that Sears may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unap-

proved modifications.You are responsible for presenting your small off-road engine to an Authorized Sears Service Dealer as soon as a problem exists. The undisputed warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have any questions regarding your warranty rights and responsibilities, you should contact a Sears Service Representative at 1-800-469-4663. The emission warranty is a defects warranty. Defects are judged on normal engine performance. The warranty is not related to an in-use emission test.

Sears Emission Control Defects Warranty Provisions

The following are specific provisions relative to your Emission Control Defects Warranty Coverage. It is in addition to the Sears engine warranty for non-regulated engines found in the Operating and Maintenance Instructions.

1.

Warranted Parts

3.

No Charge

 

Coverage under this warranty extends only to the parts listed below (the

 

Repair or replacement of any Warranted Part will be performed at no

 

emission control systems parts) to the extent these parts were present on

 

charge to the owner, including diagnostic labor which leads to the

 

the engine purchased.

 

determination that a Warranted Part is defective, if the diagnostic work is

 

a.

Fuel Metering System

 

performed at an Authorized Sears Service Dealer. For emissions warranty

 

 

• Cold start enrichment system

 

service contact your nearest Authorized Sears Service Dealer as listed in

 

 

• Carburetor and internal parts

 

the “Yellow Pages” under “Engines, Gasoline,” “Gasoline Engines,” “Lawn

 

 

• Fuel Pump

 

Mowers,” or similar category.

 

 

4. Claims and Coverage Exclusions

 

b.

Air Induction System

 

 

Warranty claims shall be filed in accordance with the provisions of the

 

 

• Air cleaner

 

 

 

 

Sears Engine Warranty Policy. Warranty coverage shall be excluded for

 

 

• Intake manifold

 

 

 

 

failures of Warranted Parts which are not original Sears parts or because

 

c.

Ignition System

 

 

 

of abuse, neglect or improper maintenance as set forth in the Sears

 

 

• Spark plug(s)

 

 

 

 

Engine Warranty Policy. Sears is not liable to cover failures of Warranted

 

 

• Magneto ignition system

 

 

 

 

Parts caused by the use of add-on, non-original, or modified parts.

 

d.

Catalyst System

 

 

5.

Maintenance

 

 

• Catalytic converter

 

 

 

Any Warranted Part which is not scheduled for replacement as required

 

 

• Exhaust manifold

 

 

 

 

maintenance or which is scheduled only for regular inspection to the effect

 

 

• Air injection system or pulse valve

 

 

 

 

of “repair or replace as necessary” shall be warranted as to defects for the

 

e.

Miscellaneous Items Used in Above Systems

 

 

 

warranty period. Any Warranted Part which is scheduled for replacement

 

 

• Vacuum, temperature, position, time sensitive valves

 

 

 

 

as required maintenance shall be warranted as to defects only for the

 

 

and switches

 

period of time up to the first scheduled replacement for that part. Any

 

 

• Connectors and assemblies

 

replacement part that is equivalent in performance and durability may

2.

Length of Coverage

 

be used in the performance of any maintenance or repairs. The owner is

 

Sears warrants to the initial owner and each subsequent purchaser that

 

responsible for the performance of all required maintenance, as defined in

 

the Warranted Parts shall be free from defects in materials and workman-

 

the Sears Operating and Maintenance Instructions.

 

ship which caused the failure of the Warranted Parts for a period of one

6.

Consequential Coverage

 

year from the date the engine is delivered to a retail purchaser.

 

Coverage hereunder shall extend to the failure of any engine components

 

 

 

 

caused by the failure of any Warranted Part still under warranty.

In the USA and Canada, a 24 hour hot line, 1-800-469-4663, has a menu of pre-recorded messages offering you engine maintenance information. GDOC-100188 Rev. A

36

Image 36
Contents Form no 30/2008Table of Contents Warranty StatementProduct Specifications Model Number Safety Instructions California PropositionTraining PreparationOperation Safe Handling of GasolineMaintenance & Storage Do not modify engineSpark Arrestor Safety Symbols SymbolSafety Labels USE CLEAN-OUT Tool to Unclog Discharge ChuteAssembly AssemblyRemoving From Crate Place the shift lever in the F6 positionChute Clean-Out Tool Set-UpDrift Cutters Adjustments Tire PressureSkid Shoes Retighten nuts and bolts securelyTesting Auger Drive Control Testing Wheel Drive Control & Speed Selector Shift LeverAdjusting Wheel Drive & Auger Controls Operation On / Off switch Chute AssemblyClean-Out Tool Recoil Starter HandleBefore Starting Engine Starting The EngineOil GasolineReplacing Shear Pins Stopping The EngineTo Engage Wheel Drive To Engage AugersService and Maintenance Reinstall oil drain plug and tighten securelyChecking Engine Oil Changing Engine OilLubrication Shave Plate and Skid Shoes Auger ShaftShave Plate Shift RodBelt replacement Service and Maintenance Drive Belt Replacement Changing Friction WheelIf also replacing the drive belt, proceed to the Drive Belt Service and Maintenance Gas in the tank † Under heavy load or in high temperatures Hole of the hex shaftOFF-SEASON Storage Preparing EnginePreparing Snow Thrower While the engine is still warm, change the oilTroubleshooting Parts List Craftsman Snow Thrower ModelHousing, Auger 684-04151 74 -0266 Washer, Flat, 1.52 ID x 2.0 ODParts List 41 -0963 Connector, Shift Rod 684-0102A 61 -0199A Bumper, Rubber 784-5619B77 -1658 Lamp 725-1669 84 -04484 Screw, 5/16-18 xCraftsman Snow Thrower Model 37 -0104 Pin, Internal Cotter From previous Page Page Page Sears Emission Control Defects Warranty Coverage This page applicable in the U.S.A. and Canada onlyGDOC-100182 Rev. a Repair Protection Agreement Here’s what the Repair Protection Agreement* includesÍndice Declaración DE GarantíaEspecificaciones DEL Producto Número DE ModeloInstrucciones DE Seguridad CapacitaciónPreparativos Operación Mantenimiento y almacenamientoColoque la palanca de cambios en posición F6 MontajeExtracción de la unidad del cajón MontajeConfiguración Herramienta de limpieza del canalCortadores de desplazamiento de nieve Dos fijadores de brida. Vea la FiguraAjustes Presión de los neumáticosZapatas antideslizantes Prueba de control de transmisión y palanca de cambios Prueba del control de la transmisión de la barrenaVea Ajuste de transmisión y controles de barrena Vuelva a ajustar bien las tuercas y los pernosOperación Manija del arrancador de retro- ceso Botón del arrancador eléctricoSalida del arrancador eléctrico BarrenasControl direccional del canal Herramienta de limpiezaAntes de encender el motor Encendido del motorDetención del motor Procedimiento para engranar la transmisiónProcedimiento para engranar las barrenas Arrancador de retrocesoServicio Y Mantenimiento Mantenimiento de MotorControl del aceite del motor Cambio de aceite del motorLubricación Placa de raspado y zapatas antideslizantes Placa de raspadoVarilla de cambio Control del canalCambio de correa Control de la transmisiónSoporte del canal Control de la barrenaReemplazo de la correa de la barrena Del motor. Vea la FiguraNota Asegúrese que la posición del regatón en la vara de Holgazán de taladro es mantenidaReemplazo de la correa de transmisión Barrena al eje de entradaMotor e instale nuevamente la cubierta de la correa Ranura de polea AdaptadorCambio de la rueda de fricción Eje hexagonalDeslice el separador sobre el extremo del eje hexagonal Cada Uso Nivel del aceite de motor Comprobar Tanque † Bajo carga pesada o en temperaturas altasAlmacenamiento Fuera DE Temporada Preparación del motorPreparación de la máquina quitanieve Almacenaje a Corto plazoSolución DE Problemas Esta página se aplica sólo en EE.UU. y Canadá Piezas con garantíaMotor certificado Acuerdo DE Protección Para Reparaciones Servicio de instalación de SearsYour Home