SAFETY INSTRUCTIONS
Maintenance & Storage
•Never tamper with safety devices. Check their proper operation regularly. Refer to the maintenance and adjustment sections of this manual.
•Before cleaning, repairing, or inspecting machine disengage all control levers and stop the engine. Wait until the auger/impeller come to a complete stop. Disconnect the spark plug wire and ground against the engine to prevent unintended starting.
•Check bolts and screws for proper tightness at frequent intervals to keep the machine in safe working condition. Also, visually inspect machine for any damage.
•Do not change the engine governor setting or
•Snow thrower shave plates and skid shoes are subject to wear and damage. For your safety protection, frequently check all components and replace with original equipment manufacturer’s (OEM) parts only. “Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety!”
•Check control levers periodically to verify they engage and disen- gage properly and adjust, if necessary. Refer to the adjustment section in this operator’s manual for instructions.
•Maintain or replace safety and instruction labels, as necessary.
•Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
•Prior to storing, run machine a few minutes to clear snow from machine and prevent freeze up of auger/impeller.
•Never store the machine or fuel container inside where there is an open flame, spark or pilot light such as a water heater, furnace, clothes dryer etc.
•Always refer to the operator’s manual for proper instructions on
•Check fuel line, tank, cap, and fittings frequently for cracks or leaks. Replace if necessary.
•Do not crank engine with spark plug removed.
•According to the Consumer Products Safety Commission (CPSC) and the U.S. Environmental Protection Agency (EPA), this product has an Average Useful Life of seven (7) years, or 60 hours of operation. At the end of the Average Useful Life have the machine inspected annually by an authorized service dealer to ensure that all mechanical and safety systems are working properly and not worn excessively. Failure to do so can result in accidents, injuries or death.
Do not modify engine
To avoid serious injury or death, do not modify engine in any way. Tampering with the governor setting can lead to a runaway engine and cause it to operate at unsafe speeds. Never tamper with factory setting of engine governor.
Notice Regarding Emissions
Engines which are certified to comply with California and federal EPA emission regulations for SORE (Small Off Road Equipment) are certified to operate on regular unleaded gasoline, and may include the following emission control systems: Engine Modification (EM), Oxidizing Catalyst (OC), Secondary Air Injection (SAI) and Three Way Catalyst (TWC) if so equipped.
Spark Arrestor
WARNING
This machine is equipped with an internal combustion engine and should not be used on or near any unimproved
If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.
A spark arrester for the muffler is available through your nearest Sears Parts and Repair Service Center.
5