Husqvarna 521SSE, 521SSR manual Checklist

Page 12

ASSEMBLY

nCHECKLIST

Before you operate your new snowthrower, to ensure that you receive the best performance and satisfaction from this quality product, please review the following checklist:

nAll assembly instructions have been completed.

nThe discharge chute rotates freely.

nNo remaining loose parts in carton.

While learning how to use your snow thrower, pay extra attention to the following important items:

nMake sure the fuel tank is filled with the correct mixture (50:1 ratio) of gasoline and Husqvarna 2 Cycle oil.

nBecome familiar with the location of all controls and under- stand their function.

nBefore starting the engine, make sure all controls operate correctly.

1740274

Image 12

Contents Operator’s Manual 1740274Introduction For Your RecordsOperating Symbols and their meanings Rules for Safe OperationTraining Children Table of Contents Safety Decals Identifying Your SnowthrowerOWNER’S Information Warranty Statement Limited WarrantyHUSQVARNA’S Obligations Under the Warranty Items not Covered by this Warranty Procedure to Obtain Warranty ConsiderationExceptions and Limitations Customer ResponsibilitiesAssembly Parts Bags ContentsTools Required for Assembly HOW to Remove the Snow Thrower from the CartonHOW to Assemble the Handle HOW to Install the ChuteChecklist Operation Know Your SnowthrowerEngine and Snow Thrower Operating Controls HOW to Stop the Snowthrower HOW to Control Snow DischargeHOW to Throw Snow HOW to Move ForwardHOW to MIX the Fuel Mixture Fuel Mixture Chart mixtureBefore Starting the Engine HOW to Stop the Engine HOW to Start the EngineHOW to Start a Cold Engine Switch boxHOW to Clear a Clogged Discharge Chute Snow Throwing TipsDRY and Average Snow WET Packed SnowService Recommendations Service RecommendationsAfter Each USE LubricationHOW to Lubricate the Idler ARM Maintenance HOW to Adjust the Belt TensionHOW to Replace the Auger Belt HOW to Replace the Scraper Blade HOW to Free the Auger CableHOW to Adjust the Chute Crank HOW to Adjust the Auger Control CableIt cannot make contact with the spark plug HOW to Replace the Drive Belt HOW to Replace the Auger To Adjust the Carburetor To Adjust or Replace the Spark PlugThis Spark Ignition System Complies with Canadian ICES-002 Storage OFF Season StorageRemoving the Snowthrower from Storage Trouble Shooting Chart Problem Look for Remedy