OPERATION
SNOWTHROWER OPERATION
The most effective use of the snowthrower will be established by experience, taking into consideration the terrain, wind conditions and building location which will determine the direction of the discharge chute.
NOTE: Do not discharge snow toward a building as hidden objects could be thrown with sufficient force to cause damage.
WARNING: Read Owner’s Manual before oper- ating machine. This machine can be dangerous if used carelessly.
Never operate the snowthrower without all guards, covers, and shields in place.
Never direct discharge toward windows or allow by- standers near machine while engine is running.
Stop the engine whenever leaving the operating posi- tion.
Disconnect spark plug before unclogging the impeller housing or the discharge chute and before making re- pairs or adjustments.
When leaving the machine, remove the ignition key. To reduce the risk of fire, keep the machine clean and free from spilled gas, oil and debris.
HOW TO STOP THE SNOWTHROWER
1.To stop throwing snow, release the auger drive lever. (See Figure 9).
NOTE: If the snowthrower continues to slowly move forward, see “How To Adjust The Auger Control Cable” in the Maintenance Section.
2.To stop the engine, move the ignition key to the OFF posi- tion.
HOW TO CONTROL SNOW DISCHARGE
1.Turn the chute control rod to set the direction of the snow throwing. (See Figure 7)
2.Loosen the wing knob on the chute deflector and move the deflector to set the distance. Move the deflector (Up) for more distance, (Down) for less distance. Then tighten the wing knob (See Figure 8).
Deflector Down | Deflector Up |
Wing Knob
Figure 8
HOW TO THROW SNOW
1.Engage the auger drive lever. (See Figure 9).
2.To stop throwing snow, release the auger drive lever.
HOW TO MOVE FORWARD
1.Hold the auger drive lever against the handle (See Figure 9). The auger will begin rotating.
2.To go forward, raise or push forward on the handle to allow the rubber auger blades to contact the ground. Maintain a firm hold on the handle as the snowthrower starts to move forward. Guide the snowthrower by moving the han- dle either left or right. Do not attempt to push the snow- thrower.
3.To stop, release the auger drive lever.
NOTE: If the auger continues to rotate, see “How To Adjust The Auger Control Cable” in the Maintenance section.
Auger
Drive Lever
Figure 9
1740274 | 14 |