Husqvarna 521SSR, 521SSE manual HOW to Replace the Scraper Blade, HOW to Free the Auger Cable

Page 21

MAINTENANCE

HOW TO REPLACE THE SCRAPER BLADE

1.Use adjustable wrenches to remove the fasteners that secure the scraper blade (Figure 16).

2.Install a new scraper blade and secure with the fasteners removed in step 1.

Scraper Blade

Figure 16

HOW TO FREE THE AUGER CABLE

IMPORTANT: If the auger cable will not move when you ENGAGE the bail, the auger cable could be frozen in- side the conduit. DO NOT pull on the auger cable. Instead, thaw the conduit and lubricate the auger cable.

1.Thaw the conduit so the auger cable moves freely.

2.Work grease into the opening on the top of the conduit where the auger cable enters.

Conduit

Figure 17

1740274

Image 21

Contents 1740274 Operator’s ManualFor Your Records IntroductionRules for Safe Operation Operating Symbols and their meaningsTraining Children Table of Contents Identifying Your Snowthrower Safety DecalsOWNER’S Information Warranty Statement Limited WarrantyHUSQVARNA’S Obligations Under the Warranty Procedure to Obtain Warranty Consideration Items not Covered by this WarrantyExceptions and Limitations Customer ResponsibilitiesParts Bags Contents AssemblyTools Required for Assembly HOW to Remove the Snow Thrower from the CartonHOW to Install the Chute HOW to Assemble the HandleChecklist Operation Know Your SnowthrowerEngine and Snow Thrower Operating Controls HOW to Control Snow Discharge HOW to Stop the SnowthrowerHOW to Throw Snow HOW to Move ForwardHOW to MIX the Fuel Mixture Fuel Mixture Chart mixtureBefore Starting the Engine HOW to Start the Engine HOW to Stop the EngineHOW to Start a Cold Engine Switch boxSnow Throwing Tips HOW to Clear a Clogged Discharge ChuteDRY and Average Snow WET Packed SnowService Recommendations Service RecommendationsAfter Each USE LubricationHOW to Lubricate the Idler ARM Maintenance HOW to Adjust the Belt TensionHOW to Replace the Auger Belt HOW to Free the Auger Cable HOW to Replace the Scraper BladeHOW to Adjust the Chute Crank HOW to Adjust the Auger Control CableIt cannot make contact with the spark plug HOW to Replace the Drive Belt HOW to Replace the Auger To Adjust the Carburetor To Adjust or Replace the Spark PlugThis Spark Ignition System Complies with Canadian ICES-002 Storage OFF Season StorageRemoving the Snowthrower from Storage Problem Look for Remedy Trouble Shooting Chart