Husqvarna 1130 SBEXP owner manual Storage, Other

Page 18

TO REMOVE WHEELS (See Fig. 25)

•Remove the klik pin and remove wheel from axle.

IMPORTANT: When installing wheel, be sure to use the axle hole closest to the end of the shaft – do not use the hole in the wheel hub (if equipped). Inner hole in axle and hole in wheel hub are not used for your model snow thrower.

KLIK PIN (INSTALL

OUTER HOLE

IN OUTER HOLE

 

OF AXLE ONLY)

 

AXLE

WHEEL

WHEEL HUB

FIG. 25

NOTE: To seal punctures or prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

ENGINE

See engine manual.

CARBURETOR

Your carburetor is not adjustable. Engine performance should not be affected at altitudes up to 7,000 feet (2,134 meters). If your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center.

ENGINE SPEED

Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the engine-governed high speed needs adjusting, contact a qualified service center, which has proper equipment and experience to make any necessary adjustments.

STORAGE

Immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.

WARNING: Never store the snow thrower with gasoline in the tank inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. Allow the engine to cool before storing in any enclosure.

SNOW THROWER

When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire snow thrower (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See “TO RE- PLACE BELTS” in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

ENGINE

See engine manual.

FUEL SYSTEM

 

IMPORTANT: It is important to prevent gum deposits from

 

forming in essential fuel system parts such as carburetor,

 

fuel hose, or tank during storage. Also, alcohol blended fuels

 

(called gasohol or using ethanol or methanol) can attract

 

moisture which leads to separation and formation of acids

 

during storage. Acidic gas can damage the fuel system of

 

an engine while in storage.

18

 

•Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in min- imizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

3.Pull recoil starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your snow thrower indoors and cover it to protect it from dust and dirt.

•Cover your snow thrower with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe, which allows condensation to form and will cause your snow thrower to rust.

IMPORTANT: Never cover snow thrower while engine/ exhaust area is still warm.

Page 17 Page 19
Image 18
Page 17 Page 19
Contents 1130SBEXP Safe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Unfold Upper HandleInstall Traction Drive Control ROD See Figs Install Auger Control ROD See FigsInstall Discharge Chute / Chute Rotater Head See Fig Install Chute Deflector Remote Control See FigsCheck Tire Pressure Primer OperationKnow Your Snow Thrower Ignition KEYMeets A.N.S.I. Safety Requirements HOW to USE Your Snow Thrower StoppingTo Throw Snow See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Move Forward and Backward See FigBefore Starting the Engine Scraper BARBefore Stopping Snow Throwing TipsTo Start Engine If Recoil Starter has FrozenGeneral Recommendations Maintenance➀ SAE 30 Motor Oil ➁ See Engine in Maintenance section Before Each USECleaning Snow ThrowerEngine Chute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Storage OtherTroubleshooting Repair Parts KEY Part Description 532 17Control Panel / Discharge Chute KEY Part Description Handles Repair Parts Drive Repair Parts Chassis / Engine / Pulleys KEY Part Description Repair Parts Wheels / Decals Wheels / Decals 532 40Rantywar Tementsta Sion Tmita ILD NA SON ITP Eexc 4ON ITC ES

1130 SBEXP specifications

The Husqvarna 1130 SBEXP is a powerful snow blower designed to tackle the challenges posed by heavy snowfall and icy conditions. With its robust construction and advanced features, it stands out as a reliable tool for both residential and commercial use.

One of the most notable features of the Husqvarna 1130 SBEXP is its impressive clearing width of 30 inches, allowing users to clear a large path quickly and efficiently. The high-performance 291cc Husqvarna engine delivers reliable power, ensuring optimal performance in even the most challenging winter conditions. This engine is designed for easy starting and operation, so users can get to work without delays.

The machine boasts a durable steel auger that not only breaks up packed snow but also effectively removes it from the surface. With the ability to throw snow up to 40 feet away, the Husqvarna 1130 SBEXP ensures that you can clear driveways, sidewalks, and patios without worrying about where the snow will land. The auger design also reduces clogging, ensuring uninterrupted performance during use.

Equipped with the innovative Hydrostatic transmission, the Husqvarna 1130 SBEXP offers smooth speed control, allowing the operator to adjust the pace according to the terrain or snow conditions. This feature adds to the machine’s versatility and user-friendliness, making it suitable for various applications.

Another highlight of this snow blower is its adjustable chute and deflector. This allows users to direct the snow exactly where they want it to go, enhancing maneuverability and effectiveness. The chute rotation can be easily controlled from the operator's position, giving you full command while clearing snow.

For added convenience, the Husqvarna 1130 SBEXP features LED headlights, ensuring visibility during early morning or late evening snow clearing. The model also includes heated handle grips for comfort, minimizing fatigue during prolonged use in cold weather.

With rugged tires designed for maximum traction and stability, the Husqvarna 1130 SBEXP excels on uneven surfaces, making it a reliable choice for any winter landscape. Its combination of power, convenience, and innovative technology positions the Husqvarna 1130 SBEXP as a leading choice in the snow blower category, ensuring that you can efficiently manage winter’s challenges while keeping your exterior spaces safe and accessible.
Top Page Image Contents