Table of Contents
Section 1: Assembly and Set-up
Land Pride
12738 |
Wheel Bracket & Wheel Arm Assembly
Figure
6.Remove wheel arm pivot shaft from wheel bracket.
7.Position the wheel arm (#10) so that the wheel points away from the seeder with cylinder bracket up. Replace wheel arm pivot shaft.
8.Pin the cylinder lock (#11) in storage position.
9.Repeat steps
Refer to Figure 1-7:
10.Install 3 1/4” x 8” x 1 1/4” hydraulic cylinder (#1) and 3 1/2” x 8” x 1 1/4” hydraulic cylinder (#2) and complete the plumbing as shown in Figure
NOTE: Your End Wheel Seeder is equipped with rephasing hydraulic lift cylinders. The plumbing must be assembled correctly in order for the rephasing cylinders to function properly.
11.Check to see all nuts are tightened. See Torque Values Chart in “Section 9: Appendix” on page 48 for torque specifications.
15258
End Wheel Hydraulic Schematic
Figure
10 PS25120 Primary Seeder | 8/21/06 |