Land Pride PS25120 manual Small Grass Seeds Attachment Optional, Seed Rate Speed Change

Table of Contents

Section 3: Adjustments

Land Pride

Small Grass Seeds Attachment (Optional)

Seed Rate Speed Change

On the left hand side of your seeder is the small grass seeds drive system. This system is designed to give you two speeds for different types of seeds and rates. The two drive types are high range (fast speed) and low range (slow speed).

To change the drive type on your small seeds drive, loosen the two set screws on the speed change sprocket, turn sprocket over and reassemble. Then remove the bolt on the small seeds drive sprocket, turn sprocket over and reassemble. If you will be using the low range, you will need to add links supplied with the kit as shown in Figure 3-5. Install chains. Adjust idlers to snug up chains.

NOTE: The 38 tooth sprocket on the three sprocket assembly is used only for the Agitator Option.

Calibrating & Adjusting Seeding Rate

Locate the seed rate adjustment handle at the rear of the small seeds box, and move it to the indicator number obtained from the seed rate charts, see page 33. For best results, first move seed rate adjustment handle all the way to the left. Then move the handle to the desired setting, moving from a lower to a higher number.

For further instructions follow directions 2 through 6, “Calibrating & Adjusting Seeding Rate” on page 20.

	12995
Low Range			High Range
	Small Grass Seeds Seed Rate Adjustment
		Figure 3-5

12996

32 PS25120 Primary Seeder 313-156M 8/21/06