Texas Instruments Comprehensive Guide to MSP-FET430UIF Driver Installation and Kit Contents

www.ti.comKit Contents, EM430Fx137RF900

	Table 1-2. Individual Kit Contents, MSP-TS430xx			(continued)
Target Socket	Socket Type	Supported Devices	Included Devices		Headers / Comment
Module
MSP-TS430PZ100B	100-pin PZ	MSP430F67xx	2 x MSP430F6733IPZ		Eight PCB 1×25-pin headers (four
	(QFP ZIF)				male and four female
MSP-	100-pin PZ	MSP430F543x,MSP430	2 x MSP430F5438IPZ		Eight PCB 1×25-pin headers (four
TS430PZ5x100	(QFP ZIF)	BT5190IPZ			male and four female
MSP-	100-pin PZ	MSP430F663x, 'F563x	2 x MSP430F6638IPZ		Eight PCB 1×25-pin headers (four
TS430PZ100USB	(QFP ZIF)				male and four female

See the device data sheets for device specifications. Device errata can be found in the respective device product folder on the web provided as a PDF document. Depending on the device, errata may also be found in the device bug database at www.ti.com/sc/cgi-bin/buglist.cgi.

1.13Kit Contents, EM430Fx137RF900

•One READ ME FIRST document

•One legal notice

•One MSP430 CD-ROM

•Two target socket module

MSP-EM430F5137RF900:Two EM430F5137RF900 target socket modules. This is the PCB on which is soldered a CC430F5137 device in a 48-pin RGZ package. A 2×7-pin male connector is also present on the PCB

MSP-EM430F6137RF900:Two EM430F6137RF900 target socket modules. This is the PCB on which is soldered a CC430F6137 device in a 64-pin RGC package. A 2×7-pin male connector is also present on the PCB

•Two CC430EM battery packs

•Four AAA batteries

•Two 868-/915-MHz antennas

•Two 32.768-kHz crystals

•18 PCB 2×4-pin headers

1.14Hardware Installation, MSP-FET430PIF

Follow these steps to install the hardware for the MSP-FET430PIF tools:

1.Use the 25-conductor cable to connect the FET interface module to the parallel port of the PC. The necessary driver for accessing the PC parallel port is installed automatically during CCE/CCS or IAR Embedded Workbench installation. Note that a restart is required after the CCE/CCS or IAR Embedded Workbench installation for the driver to become active.

2.Use the 14-conductor cable to connect the parallel-port debug interface module to a target board, such as an MSP-TS430xxx target socket module. Module schematics and PCBs are shown in Appendix B.

SLAU278F –May 2009 –Revised December 2010	Get Started Now!	19
Submit Documentation Feedback

© 2009–2010, Texas Instruments Incorporated