www.ti.com

MSP-FET430UIF

B.29.1 MSP-FET430UIF Revision History

Revision 1.3

Initial released hardware version

Assembly change on 1.3 (May 2005)

R29, R51, R42, R21, R22, R74: value changed from 330R to 100R

Changes 1.3 to 1.4 (Aug 2005)

J5: VBUS and RESET additionally connected

R29, R51, R42, R21, R22, R74: value changed from 330R to 100R

U1, U7: F1612 can reset TUSB3410; R44 = 0R added

TARGET-CON.: pins 6, 10, 12, 13, 14 disconnected from GND

Firmware-upgrade option through BSL: R49, R52, R53, R54 added; R49, R52 are currently DNP

Pullups on TCK and TMS: R78, R79 added

U2: Changed from SN74LVC1G125DBV to SN74LVC1G07DBV

NOTE: Using a locally powered target board with hardware revision 1.4

Using an MSP-FET430UIF interface hardware revision 1.4 with populated R62 in conjunction with a locally powered target board is not possible. In this case, the target device RESET signal is pulled down by the FET tool. It is recommended to remove R62 to eliminate this restriction. This component is located close to the 14-pin connector on the MSP-FET430UIF PCB. See the schematic and PCB drawings in this document for the exact location of this component.

Assembly change on 1.4 (January 2006)

R62: not populated

SLAU278F –May 2009 –Revised December 2010

Hardware

127

Submit Documentation Feedback

 

 

© 2009–2010, Texas Instruments Incorporated

Page 127
Image 127
Texas Instruments MSP430 manual MSP-FET430UIF Revision History