Texas Instruments MSP430 manual Table B-3. MSP-TS430L092 JP1 Settings, Jumper Description

www.ti.com MSP-TS430L092 Active Cable

Figure B-6shows the PCB layout for the Active Cable. The following pinning is possible:

•JP1 has two jumpers (Jumper 1 and Jumper 2) that can be set as shown in Table B-3.

Table B-3. MSP-TS430L092 JP1 Settings

Jumper 1	Jumper 2	Description
Off	Off	The active cable has no power and does not function.
Off	On	The active cable receives power from target socket. For this option, the
		target socket must have its own power supply.
On	Off	The active cable receives power from the JTAG connector.
		The JTAG connector powers the active cable and the target socket. For
On	On	this option, the target socket must not have its own power source, as this
		would cause a not defined state.

•JP2 is for reset. For the standard MSP-TS430L092, this jumper must be set. It sets the reset pin to high and can also control it. Without this jumper on the MSP-TS430L092, reset is set to zero.

Figure B-6. MSP-TS430L092 Active Cable Target Socket Module, PCB

SLAU278F –May 2009 –Revised December 2010	Hardware 41
Submit Documentation Feedback

© 2009–2010, Texas Instruments Incorporated