Land Pride PS25120 manual Pull-Type Primary Seeder with Front Wheels, Accumulator Assembly

Page 13

Land Pride

Table of Contents

Section 1: Assembly and Set-up

Pull-Type Primary Seeder with Front Wheels

!WARNING

Serious injury or death could result from escaping high pressure hydraulic fluid. Use paper or cardboard, NOT BODY PARTS, to check for suspected leaks.

1.Remove the seeder and components from their crating.

2.Refer to Figure 1-3 on page 8 for installation of the acremeter on to the right hand drive shaft.

3.Install spring hose loop, Figure 1-5 on page 8.

!CAUTION

The Accumulator/Cylinder Package furnished with your front wheel option is provided for your protection. Lack of or improper installation may result in injury or in damage to your seeder because of the negative tongue weight involved with the front wheels.

4.Attach the tongue to the seeder with hitch pins.

5.Refer to Figure 1-8 and attach the accumulator bracket and accumulator to the rear of the tongue as shown, fastening with hose clamps provided.

12739

Accumulator Assembly

Figure 1-8

6.Refer to Figure 1-10 and install hydraulic cylinder with single lug (#1) to tongue and top hitch as shown.

7.Complete the plumbing by following the schematic in Figure 1-9. The plumbing must be assembled correctly in order for the accumulator to function properly. Route the hydraulic hoses (#1) along the tongue. These hoses will be clamped together with the wheel cylinder hoses in step 13.

15501

Accumulator Hydraulic Schematic

Figure 1-9

Refer to Figure 1-10:

8.Install the wheel bracket (#2) using 3/4" u-bolts (#3), flat washers (#4) and nuts (#5). The wheel bracket should be facing the front of the seeder. To determine the correct positioning for the wheel brackets, note the tab (#6) on the end of the wheel arm pivot (#7). This tab should be toward the outside of the seeder, as shown, so the wheel arm pivot can be easily removed.

NOTE: The corresponding wheel brackets must be positioned with the 1" hole over the front wheel locating stub (#8) on the frame as shown for proper distribution of seeder weight when in transport. Locating the brackets at any other place on the frame could result in damage to the seeder.

9.Remove wheel arm pivot shaft from wheel bracket.

10.Position the wheel arm (#9) so that the wheel points toward the outside of the seeder with cylinder bracket up. Replace wheel arm pivot shaft.

11.Pin the cylinder lock (#10) in storage position.

12.Repeat steps 9-11 for the right hand side.

8/21/06

PS25120 Primary Seeder 313-156M 11

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Primary Seeder Table of Contents Safety at All Times Use a Safety Chain Use Safety Lights and DevicesPractice Safe Maintenance Transport Machinery SafelyWear Protective Equipment Prepare for EmergenciesAvoid High Pressure Fluids Hazard Keep Riders Off Machinery818-230C 818-003C818-337C 818-229C818-339C 818-340C818-338C Application Using This ManualOwner Assistance Sling Bracket Installation Pre-Assembly ChecklistParking Stand Installation Sling BracketsTongue & Turnbuckle Assembly Acremeter InstallationSpring Hose Loop Assembly Pull-Type Primary SeederEnd Wheel Hydraulic Schematic Wheel Bracket & Wheel Arm AssemblyAccumulator Hydraulic Schematic Accumulator AssemblyPull-Type Primary Seeder with Front Wheels Front Wheel Hydraulic Schematic Cylinder, Wheel Bracket & Wheel Arm AssemblyOperating Check List General DescriptionTractor Requirements Tractor 3-Point Hook-UpPull-Type and End Wheel Units Tractor Drawbar Hook-UpFront Wheel Units Bleeding Hydraulic System Tractor Hydraulic Hook-UpOperating Hydraulic Lift System TransportingPoint Seeders ParkingPull-Type, Front or End Wheel Seeders Seed Level Indicator Seed Level IndicatorAgitator Attachment Optional General Operating InstructionsRoller Packing Wheels Drive SystemSeed Broadcasting System Seed Rate Speed ChangeHigh Range Low RangeAg Drive Low Range High Range Turf DriveSeed Rate Adjustment Calibrating & Adjusting Seeding RateFescue Fine Blade, Turf Type Pounds per Acre Seed Rate Charts for Ag DriveFescue Fine Blade, Turf Type Pounds per 1000 Square Feet Lovegrass Sand Pounds per Acre Kentucky Blue Grass Pounds per AcreRye Grass Annual Pounds per Acre Rye Grass Perennial Pounds per AcreWheatgrass Crested Pounds per Acre Brome Grass Seed Rate ChartWheatgrass Western Pounds per Acre Clover Red Metric Seed Rate Charts for Ag DriveClover White Fescue Fine Blade, Turf Type Kilograms per HectareFescue K-31 Metric Brome Seed Rate Chart Bent Grass Pounds per Acre Seed Rate Charts for Turf Drive28 PS25120 Primary Seeder 313-156M Metric Seed Rate Charts for Turf Drive Clover White Kilograms per 1000 Square Meters Fescue K-31Kilograms per HectarePerennial Kilograms per Hectare Rye GrassSmall Grass Seeds Seed Rate Adjustment Calibrating & Adjusting Seeding RateSmall Grass Seeds Attachment Optional Seed Rate Speed ChangeBird’s-foot Trefoil Pounds per Acre Small Grass Seeds Attachment Seed RatesMillet Kilograms per Hectare Lespedeza Unhulled Kilograms per 1000 Square MetersMillet Pounds per 1000 Square Feet Red Top Kilograms per HectareSmall Grass Seeds Attachment Metric Seed Rates Millet Kilograms per 1000 Square Meters Fescue K-31Kilograms per 1000 Square MetersHeight Adjustment Calibrating and Adjusting Seed RateCoil Tines Optional Danish Tines OptionalAdjustment w/o Small Grass Seeds Attach Adjustment w/ Small Grass Seeds AttachWalkboard Optional Storage MaintenanceLubrication RequiredSeasonally HoursFeeder Cup Drive Sprocket Small Grass Seeds Attachment Drive Sprocket Hanger Bearing Small Grass Seeds AttachmentAgitator Lockout Agitator Attachment Agitator Attachment 313-079A Small Seeds Attachment 313-113ACoil Tine Track Removers 313-078A Walkboard 313-130A Danish Tine Track Removers 313-077ABushel Seeders PS25 Series Primary SeederBushel and 30 Bushel Seeders Pull-Type with Front Wheels Bushel and 30 Bushel Seeders Pull-Type with End WheelsFeatures & Benefits Acremeter doesn’t measure accurately Problem SolutionRaising and lowering seeder is rough or Feed cup sprocket locked up or twistedTire Inflation Chart Torque Values ChartTire Size Inflation 5L x 15 8-Ply Rib ImplementWarranty Corporate Office P.O. Box Salina, Kansas 67402-5060 USA
Top Page Image Contents