33
If Your Smart Drive® Beeps for Help
Your Smart Drive® is capable of diagnosing its own troubles. If your Smart Drive® gives a musical
series of beeps every 5 seconds it is telling you that it has a problem which YOU can solve using
the checklist below.
* The beeps are the same sound your autowasher makes when you turn it on at the wall.

Musical Series of Beeps* Every 5 Seconds and... Possible Solutions

HOT water temperature light is flashing.

Hot water supply is not hot enough to maintain the wash temperature you have selected. Select a
lower wash temperature.
Inlet hose screens may be blocked.
There may be a kink in the hose (Refer to page 5).
Hot tap has not been turned on.
Inlet hoses connected to the wrong taps.

COLD water temperature light is flashing.

Cold tap has not been turned on.
Inlet hose screens may be blocked.
There may be a kink in the hose. (Refer to page 5).
Inlet hoses connected to the wrong taps.
Cold water temperature exceeds recommended limits. (See Installation Instructions page 6).
The flow rate of the supply water is too slow.

HOT and COLD water temperature lights are flashing.

The taps have not been turned on.
Inlet hose screens may be blocked.
The hoses may be kinked. (Refer to page 5).
The drain hose is too low or the drain hose is pushed into the standpipe too far and the water is
siphoning out of the machine. (See Installations Instructions page 4).
The flow rate of the supply water is too slow.

HIGH water level light is flashing.

The machine is overloaded and can not agitate. Ensure the machine is stationary. Remove items
until the remaining ones can move freely.
Select a higher water level.

The first RINSE light or SPIN light is flashing.

The machine has a suds build-up. (Too much detergent may have been used for the amount of soil
in the load.) Wait for suds to dissolve (about 20min). Rinse clothes using a deep rinse.