Adjustment of the Scope on the Rifle | Newcon Optik DN482, DN483

7.ADJUSTMENT OF THE SCOPE ON THE RIFLE

Type and dimensions of the reticle

The type and dimensions are represented on the drawing. The brightness of the reticle may be adjusted by the knob (8). The dimensions are quoted in meters for the 100 m distance.

For a distance other than 100m the dimensions must be calculated accordingly in proportion.

Before adjusting of the scope its objective should be set for a distant object (select infinity) in dark time with the opened cover of the objective.

The adjustment of the scope should be performed either in daytime with the closed cover of the objective or in the twilight using an adjusted target or a remote point.

Adjustment of the scope is performed in the following way:

•Fix the scope on the rifle.

•Set a panel with a target or select the point of aiming.

•Set the rifle on the scope machine.

•Direct the rifle to the point of aiming by mechanical sight (bead with a slot) (if possible). At this stage it is suitable to apply laser of cold test shooting (LCTS) inserted in the barrel of the rifle, which indicates geometrical point of the barrel position (sold separately).

•Unscrew the protective caps of the reticle adjustment screws. Turning those screws obtain the matching of reticle crosshairs with the aimed point, set by the mechanical sight or LCTS;

•Remove the rifle from scoped machine and take out LCTS;

•Make 2-3 shots. Having examined the target make necessary corrections (for example, in order to move the hit point downwards and leftwards, screws of the mechanism should be turned counter clockwise, in the directions Down and Left correspondingly. The aiming point is moving upwards and rightwards correspondingly);

4. SUPPLIED ACCESSORIES

DN482/483 is supplied in the following assembly:

- Device	1 pc.
- Objective lens cap	1 pc.
- Rubber eyepiece guard	1 pc.
- Weaver rifle mount	1 pc.
- User’s manual	1 pc.
- Warranty card	1 pc.
- Case	1 pc.
Optional accessories:	1 pc.
-Weaver rail rifle mount (7/8’’)	1 pc.
- Built-in IR illuminator	1 pc.
- Camera/video adapter (52mm/37mm)	1 pc./each
-Side mount for East European type rifle.	1 pc.

5. OPERATION INSTRUCTIONS

WARNING!

NEVER OPERATE YOUR NIGHT VISION DEVICE IN DAYLIGHT AREAS WITHOUT THE LENS COVER ON! NEVER AIM THE LENS IN THE DIRECTION OF BRIGHT LIGHT!

a. Battery installation

DN482/483 requires two AA batteries. Make sure that the batteries are in good condition and polarity is installed as it is indicated on the body of battery compartment (5).

In order to change the batteries unscrew the cover of battery compartment (5) and install the new batteries, observing correct polarity.

NOTE: In order to ensure the longest operation time of the device and full power of the IR illuminator (using one set of batteries) it is