Removing the Fan, Heat Sink, and Processor

A – Heat Sink

D – Processor

B – Retention Clip

E – Retention Clip Flange

C – Locking Lever

 

Installing an Upgrade Processor

Install the upgrade processor as follows.

1.Remove the processor currently in the system (see “Removing the Processor” in the previous section).

Before picking up the processor, reduce static discharge by touching the metal chassis.

2.Align the triangle on the corner of the processor with the letters “CPU1” on the system board.

3.Carefully align the processor pins with the socket pin holes and set the processor into the socket.

!If aligned correctly and the pins are not bent, the processor seats in the socket without forcing.

!If the processor does not seat, check for correct alignment and bent pins.

4.Pivot the lever down and press it in towards the socket until it locks in place.

Using the wrong heat sink or no heat sink can damage the processor, system board, or both. Ensure that the update processor has the correct heat sink (refer to the documentation that comes with the kit).

Additional information can be obtained from NECC (see Section 8, “NEC Information Services” for information on contacting NECC).

Disassembly and Reassembly 3-17

Page 75
Image 75
NEC PowerMate CT manual Installing an Upgrade Processor, Removing the Fan, Heat Sink, and Processor, Locking Lever