NEC PowerMate CT manual Expansion Boards, Replacing the Front Panel

Replacing the Front Panel

Replace the front panel as follows.

1.Align the three tabs (B) on the inside edge of the front panel with their corresponding slots (A) on the lower edge of the chassis (see the following figure).

2.Insert the tabs into their slots and press the front panel up against the chassis until the front panel locks in place.

3.Replace the cover (see “Replacing the Cover” earlier in this section).

Replacing the Front Panel

A – Slots on Chassis (3)	C – Front Panel
B – Tabs on Front Panel (3)	D – Chassis Front

Expansion Boards

The following sections describe how to:

!remove and replace the retainer bar, which secures expansion boards and slot covers

!remove and replace expansion boards

!remove and replace slot covers.

The following figure shows the locations of the expansion slots on the chassis and the expansion board connectors on the system board.

3-6 Disassembly and Reassembly