NEC PowerMate CT manual JP3, Ram, Bios JP5

System Board Jumper Block Settings

Function	Jumper	Setting	Description
Rear USB	JP3	2-3	Factory setting. Enables system
Device			wakeup via input from the rear USB
Wakeup			port.
		1-2	Disables system wakeup via input from
			the rear USB port.
PS/2	JP16	2-3	Factory setting. Disables the keyboard
Keyboard at			at power on.
Power On		1-2	Enables the keyboard at power on.
Save to	JP18	Jumpered	Factory setting. Enables Suspend to
RAM			RAM (STR) function. In STR mode, the
			system saves to memory all
			configuration information and all
			running programs. When the system
			leaves Suspend mode, it restores
			everything from memory.
		Open	Disables Save to RAM function.
BIOS	JP5	1-2	Factory setting. Sets the system for
Recovery			normal operation. The BIOS uses
			current configuration information and
			passwords at power on.
			To enable BIOS recovery for a
			corrupted system, remove the jumper.
			Wait 10 seconds. Replace the jumper
			on pins 1 and 2.
		2-3	Restores Safe BIOS settings as the
			default BIOS settings and loads the
			BIOS Setup at power on.
USB Port	JP27,	1-2	Factory setting. Enables the front USB
Selection	JP28	1-2	port and rear USB port.
		2-3	Disables the front USB port and
		2-3	enables the rear USB port.
Front USB	JP21	2-3	Factory setting. Disables system
Device			wakeup from the USB device
Wakeup			connected to the front USB port.
		1-2	Enables system wakeup from the USB
			device connected to the front USB port.

2-6 System Configuration