NEC PowerMate CT Installing a 3 1/2-Inch Accessible Device, 3 1/2-Inch Accessible Device Bracket

The 3 1/2-Inch Accessible Device Bracket

A – Side Tabs on Bracket Cover	C – Best Approach for
B – Drive Screws (two of four)	Unlatching Side Tabs

7.Slide the device out the front of the bracket.

8.If you are installing another 3 1/2-inch accessible device, see “Installing a 3 1/2-Inch Accessible Device.” If you are not installing a new device at this time, continue with step 9.

9.Press the plastic bay cover over the opening in the bracket cover.

10.Press the bracket cover over the front shield so the two side tabs click into place.

11.Slide the bracket into the chassis. The tab at either side of the bracket should click into place.

12.If there is still a device in the other bay of the bracket, reconnect its power and signal cables.

13.Replace the front panel (see “Replacing the Front Panel”).

14.Replace the system unit cover (see “Replacing the Cover”).

Installing a 3 1/2-Inch Accessible Device

Install a new device in the bracket, and then install the bracket in the system.

Before removing the cover, turn off system power and unplug the system power cable. Power is removed only when the power cable is unplugged.

1.Follow the procedures in steps 1 to 8 in the previous section, “Removing a 3 1/2-Inch Accessible Device,” to remove the two-device bracket and (if applicable) the old device from the system.

2.If you are installing the device in an empty bay, uncover the bay:

!remove the 3 1/2-inch plastic bay cover from the bracket cover by pressing its tabs together while pushing it out of its opening

!remove the breakaway shield (if any) from the front shield by twisting it gently until it comes off.

3.Slide the new device into the front of the bracket, connector end first.

Disassembly and Reassembly 3-25