NEC PowerMate CT manual Removing an Expansion Board, Expansion Board AGP Video Board Locking Lever

Removing an Expansion Board

Remove an expansion board as follows.

1.Remove the cover (see “Removing the Cover” earlier in this section).

2.Label and unplug any cables connected to the board.

3.Remove the retainer bar (see “Removing the Retainer Bar”).

4.Pull the board out of the connector and expansion slot. Set the board on an antistatic surface.

If you are removing an AGP board, press out on the board’s locking lever while pulling the board out of its connector.

Removing an Expansion Board

A – Expansion Board B – AGP Video Board Locking Lever

5.Install a new board, or install the slot cover if you are not installing a board.

!If you are adding an expansion board, see “Installing an Expansion Board.”

!If you need to install a slot cover, see “Installing a Slot Cover.”

3-8 Disassembly and Reassembly