NEC PowerMate CT manual Nmi, Smi, Sci

Advanced Menu

Menu Item	Settings (default is bold)
ECC Error Type	SMI, SCI, None, NMI
	When a ECC error occurs, it generates an interrupt. Select
	the type of interrupt to report:
	NMI	Non-Maskable
	SMI	System Management
	SCI	System Control
SERR Signal Condition	Multiple bit, Both, None, Single Bit
	Select ECC error conditions that SERR# be asserted.
Pool A Capacity	8, 1, 2, 4
	This field defines the maximum number of RDRAM devices
	that can reside in Pool A at a time. The devices that are not
	part of Pool A belong in Pool B.
Pool A Active Device	4, 1, 2, 3
	This field defines the maximum number of RDRAM devices
	in Pool A that can be Active Read/Write or Active state at a
	time. The devices in Pool A that are not in Active state are in
	Standby state.
Pool B Power State	Nap, Standby
	This field selects the operating state of the RDRAM devices
	in Pool B. All devices in Pool B are in Standby or Nap state.
ACPI Standby State	S1, S3
	Choose one of the ACPI states.
QuickBoot Mode	Disabled, Enabled
	When Enabled, allows the system to skip certain tests while
	booting. This decreases the time needed to boot the system.
AC97 Audio	Enabled, Disabled
	Enables or disables the integrated Audio Interface.
AC97 Modem	Enabled, Disabled
	Enables or disables the integrated Modem Interface.
DMI Event Logging	Press Enter to access the following submenus.
Event Log Capacity	Status only.
Event Log Validity	Status only.
View DMI Event Log	Status only, press Enter to view the Event Log.
Clear All DMI Event Logs	No, Yes
	Selecting No prevents clearing out the DIMM event logs.
	Selecting Yes will clear the PMI event log after rebooting.

System Configuration 2-17