6.Replace all devices, covers, and rails in the accessible device cage so they sit sideways in the drive cage, with their top surfaces toward the right end of the chassis (see the following figure). Place them in the same order they were in before. See the following sections for the procedures.

!“Storing and Retrieving Unused Rails”

!“Replacing a Bay Cover”

!“Installing a 5 1/4-Inch Accessible Device”

!“Installing a 3 1/2-Inch Accessible Device”

Accessible Device Placement for a Minitower

A – 3 1/2-Inch Bracket

B – 5 1/4-Inch Bays

7.Remove the logo plate by unclipping its tabs from inside the front panel. Position the logo plate so it is readable when the chassis is in the vertical position. Press the tabs into the front panel until they click in place.

8.Replace the front panel (see “Replacing the Front Panel”).

9.Replace the system cover (see “Replacing the Cover”).

10.Place the system unit in a vertical position. The power button and the lamps on the control panel should run from left to right. The drives should be right-side up in the drive cage.

11.Reconnect any external options (such as a keyboard and monitor) to the front or rear of the system unit.

12.Reconnect the power cable to the system and to a properly grounded wall unit or surge protector.

Disassembly and Reassembly 3-39

Page 97
Image 97
NEC PowerMate CT manual Accessible Device Placement for a Minitower