NEC PowerMate CT manual Replacing the Retainer Bar

Replacing the Retainer Bar

Install the retainer bar as follows.

1.Hold the retainer bar at an angle and insert the ends (A) into the slots (B) in the chassis (see the following figure).

2.Push the bar into the slots and under the edge of the chassis.

3.Press down on the lock tabs (C) and firmly push the bar in until the tabs slide into their slots (D). Be sure that the raised portion on each tab locks into the slot (D).

4.Replace the cover (see “Replacing the Cover”).

Replacing the Retainer Bar

A – Retainer Bar End	C – Lock Tab
B – Retainer Bar Slot	D – Lock Tab Slot

Disassembly and Reassembly 3-11