NEC PowerMate CT manual Installing a Slot Cover, Removing a Slot Cover

Installing a Slot Cover

Install a slot cover as follows.

1.Slide the slot cover into the expansion board slot (see the following figure).

Make sure the narrowed end of the slot cover goes into the metal strap. Its top edge should fit around the raised hole in the edge of the chassis.

2.Replace the expansion board retainer bar (see “Replacing the Retainer Bar” later in this section).

3.Replace the cover (see “Replacing the Cover” earlier in this section).

Installing a Slot Cover

A – Slot Cover

Removing a Slot Cover

Remove a slot cover as follows.

1.Slide the slot cover up to free it from the chassis (see the previous figure).

2.Save the slot cover for future use.

3.Install an expansion board (see “Installing an Expansion Board”).

4.Secure the expansion board in place with the retainer bar (see “Replacing the Retainer Bar”).

5.Attach any signal cables required by the expansion board.

6.Replace the cover (see “Replacing the Cover” earlier in this section).

Disassembly and Reassembly 3-9